Search results
Results from the WOW.Com Content Network
To take a common example, 195/55R16 would mean that the nominal width of the tire is approximately 195 mm at the widest point, the height of the side-wall of the tire is 55% of the width (107 mm in this example) and that the tire fits 16-inch-diameter (410 mm) rims. The code gives a direct calculation of the theoretical diameter of the tire.
Tire uniformity refers to the dynamic mechanical properties of pneumatic tires as strictly defined by a set of measurement standards and test conditions accepted by global tire and car makers. These standards include the parameters of radial force variation , lateral force variation , conicity, ply steer, radial run-out , lateral run-out , and ...
For premium support please call: 800-290-4726 more ways to reach us
The European Tyre and Rim Technical Organisation (ETRTO) exists to specify and harmonise sizes of rims and their associated pneumatic tyres across the European Union.ETRTO sizes apply to rims and tyres for vehicles of all types, including bicycles.
These represent the tire's resistance to the generation of heat at speed. Tires graded A effectively dissipate heat up to a maximum speed that is greater than 115 mph. B rates at a maximum between 100 mph and 115 mph. C rates at a maximum of between 85 mph to 100 mph. Tires that cannot grade up to C or higher cannot be sold in the US. [9]
Plus sizing is the practice of replacing an automotive wheel with one of a larger diameter fitted with a new tire of lower aspect ratio so that the new tire has close to the same diameter and circumference as the original tire to minimize any changes in speedometer accuracy, torque and traction control, while reducing sidewall flex and (generally) increasing cornering ability.
In the tire factory, the tire and wheel are mounted on a balancing machine test wheel, the assembly is rotated at 100 r/min (about 5–7 m/s (18–25 km/h; 11–16 mph) with recent high sensitivity sensors) or higher, 300 r/min (about 25–27 m/s (90–97 km/h; 56–60 mph) with typical low sensitivity sensors), and forces of unbalance are ...
The inner width of the rim on which the tire is mounted should be about 65% of the tire's nominal section width for tires smaller than 30 mm and 55% for those larger. The section height of a tire is usually identical to its section width (for tires less than 28 mm, 2.5 mm have to be added to the width to get the height).