Search results
Results from the WOW.Com Content Network
Rock Chuck Bullet Swage (later abbreviated RCBS) is a handloading equipment manufacturer operating in Oroville, California. The company originated during the sporting ammunition shortage caused by World War II , became a widely recognized manufacturer of handloading equipment, and has subsequently been purchased by Hodgdon Powder Company .
It had a six-shot, rotating cylinder, and fired a 0.454-inch-diameter (11.5 mm) round spherical lead ball, or a conical-tipped bullet, typically propelled by a 30-grain charge of black powder, which was ignited by a small copper percussion cap that contained a volatile charge of fulminate of mercury (a substance that explodes upon being ...
Drawings of various types of semiwadcutter bullets 4-cavity Keith semiwadcutter bullet mold, the Lyman 358429. The semiwadcutter design consists of a roughly conical shape with the tip truncated flat (called a meplat), sitting on a cylinder (A at right). The base of the cone is slightly smaller in diameter than the cylinder, leaving a sharp ...
Components of a modern bottleneck rifle cartridge. Top-to-bottom: Copper-jacketed bullet, smokeless powder granules, rimless brass case, Boxer primer.. Handloading, or reloading, is the practice of making firearm cartridges by manually assembling the individual components (metallic/polymer case, primer, propellant and projectile), rather than purchasing mass-assembled, factory-loaded ...
It was originally named the MMJ 5.7mm [1] by its designer and is also known in the U.S. as the 5.7mm Johnson, the Johnson MMJ 5.7mm Spitfire, and the .22 Johnson, (or 5.7×33mm internationally). In 1963, Melvin M. Johnson developed a conversion of the M1 Carbine (by either relining or re-barreling the M1 Carbine ) to a .224 caliber bore, using ...
The Enfield Pattern 1853 rifle-musket (also known as the Pattern 1853 Enfield, P53 Enfield, and Enfield rifle-musket) was a .577 calibre Minié-type muzzle-loading rifled musket, used by the British Empire from 1853 to 1867; after which many were replaced in service by the cartridge-loaded Snider–Enfield rifle.
An open single-cavity bullet mold and a closed two-cavity mold. A cast bullet is made by allowing molten metal to solidify in a mold.Most cast bullets are made of lead alloyed with tin and antimony; but zinc alloys have been used when lead is scarce, and may be used again in response to concerns about lead toxicity.
5.45×18mm 7N7 (7Н7): spitzer-pointed full metal jacket bullet with steel conical core. [3] The bullet energy is stated to be up to 1.5 times that of .25 ACP in a similar sized cartridge. It is stated to be capable of penetrating 45 layers of Kevlar soft body armor at close distances. [4] 5.45×18mm PSO (ПСО): spitzer-pointed full metal ...