Search results
Results from the WOW.Com Content Network
The goal of EGR is thus to reduce NO x production by reducing the combustion temperatures. In modern diesel engines, the EGR gas is usually cooled with a heat exchanger to allow the introduction of a greater mass of recirculated gas. However, uncooled EGR designs do exist; these are often referred to as hot-gas recirculation (HGR).
For twin-cam or DOHC engines, VCT was used on either the intake or exhaust camshaft. (Engines that have VCT on both camshafts are now designated as Ti-VCT.↓) The use of variable camshaft timing on the exhaust camshaft is for improved emissions, and vehicles with VCT on the exhaust camshaft do not require exhaust gas recirculation (EGR) as retarding the exhaust cam timing achieves the same ...
PCV valve on Ford Taunus V4 engine (feeding from left side valve cover into the inlet manifold) A crankcase ventilation system (CVS) removes unwanted gases from the crankcase of an internal combustion engine. The system usually consists of a tube, a one-way valve and a vacuum source (such as the inlet manifold).
A 3-port solenoid-type boost controller A 4-port solenoid-type boost controller (used for a dual-port wastegate). The purpose of a boost controller is to reduce the boost pressure seen by the wastegate's reference port, in order to trick the wastegate into allowing higher boost pressures than it was designed for.
Swirl flap principle in a four-valve engine. A swirl flap is a small butterfly valve fitted to four-stroke internal combustion engines with at least two intake valves.It is installed inside or just before one of a cylinder's two intake ports, allowing to throttle its intake port's air flow, causing a swirl in the other intake port not fitted with a swirl flap.
Pumped air injection systems use a vane pump called the air pump, AIR pump, or colloquially "smog pump" turned by the engine via a belt or electric motor.The pump's air intake is filtered by a rotating screen or the vehicle air filter to exclude dirt particles large enough to damage the system.
The way they do this is during a deceleration of the vehicle when there is low absolute pressure in the intake manifold (i.e., a high vacuum present in the intake manifold relative to the outside air) the powertrain control module (PCM) will open the EGR valve and then monitor the MAP sensor's values. If the EGR is functioning properly, the ...
The Ford EDIS or Electronic Distributorless Ignition System is a computer-controlled ignition system developed by Ford that uses an ignition coil for each pair of cylinders (wasted spark). All the coils are placed in a single module called a coilpack.