enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Square nut - Wikipedia

   en.wikipedia.org/wiki/Square_nut

   Square nuts are typically mated with square-headed bolts. Square nuts are used along with flat washers to avoid damage from its sharp edges and increase the strength of the fastener. Square nuts can have standard, fine or coarse threading with platings of zinc yellow, plain, zinc clear, tin and cadmium, among others. Most can meet either the ...

3. Nut (hardware) - Wikipedia

   en.wikipedia.org/wiki/Nut_(hardware)

   Four-sided nut. Compared to standard hex nuts, square nuts have a greater surface in contact with the part being fastened, ... 3 ⁄ 16: 0.1875 4.763 5.18

4. Wrench size - Wikipedia

   en.wikipedia.org/wiki/Wrench_size

   Sizes that may interchange, depending on the precision needed, include 2 mm (close to 5 ⁄ 64 inch (1.98 mm)), 4 mm (close to 5 ⁄ 32 inch (3.97 mm)) and 8 mm (close to 5 ⁄ 16 inch (7.94 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.

5. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   M6 and M8 triple square drivers End view of M10 triple square screw. The triple-square, also known as XZN, is a type of screw drive with 12 equally spaced protrusions, each ending in a 90° internal angle. The name derives from overlaying three equal squares to form such a pattern with 12 right-angled protrusions (a 12-pointed star).

6. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   In 1913, Woolley and Meredith defined them like Anthony, but gave the following dimensions: hex head cap screws up to and including 7 ⁄ 16 inch (11.1125 mm) have a head that is 3 ⁄ 16 inch (4.7625 mm) larger than the shank diameter; screws greater than 1 ⁄ 2 inch (12.7 mm) in diameter have a head that is 1 ⁄ 4 inch (6.35 mm) larger than ...

7. Square thread form - Wikipedia

   en.wikipedia.org/wiki/Square_thread_form

   The greatest advantage of square threads is that they have a much higher intrinsic efficiency than trapezoidal threads (Acme or metric trapezoidal). Due to the lack of a thread angle there is no radial pressure, or bursting pressure, on the nut. This also increases the nut life. [1] The greatest disadvantage is the difficulty in machining such ...