Search results
Results from the WOW.Com Content Network
Diagonal- and stepped-cut rift-sawing is intermediate to flat-sawn and radial cut lumber. The angle of the bastard grain may differ along the width of the board or between opposing sides, and enhances the appearance of ray fleck. Flat-sawing is the quickest method, producing the least wood waste and largest possible boards from a log.
Riftsawn wood has every board cut along a radius of the original log, so each board has a perpendicular grain, with the growth rings oriented at right angles to the surface of the board. However, since this produces a great deal of waste (in the form of wedge-shaped scraps from between the boards) rift-sawing is very seldom used.
Lumber can be quickly flat-cut with a side-by-side set of mechanical saws. [3] A slower but sturdier method involves passing the log back and forth over a single saw. To reduce buckling that may occur along the middle of flat-cut boards, the initial cut may be offset from the diameter, and resulting sections cut further before cutting the flitches.
20V MAX 7-1/4-Inch Miter Saw. Featuring built-in carrying handles and a convenient, compact size, miter saws don’t get much more portable than this 30-pound model from DeWalt.
90º miter joint (pieces ready to be joined) Miter joint of two pipes A miter joint (mitre in British English) is a joint made by cutting each of two parts to be joined, across the main surface, usually at a 45° angle, to form a corner, usually to form a 90° angle, though it can comprise any angle greater than 0 degrees.
A circular saw is a tool for cutting many materials such as wood, masonry, plastic, or metal and may be hand-held or mounted to a machine. In woodworking the term "circular saw" refers specifically to the hand-held type and the table saw and chop saw are other common forms of circular saws.
Bucking is the process of cutting a felled and delimbed tree into logs. [2] Significant value can be lost by sub-optimal bucking because logs destined for plywood, lumber, and pulp each have their own value and specifications for length, diameter, and defects. Cutting from the top down is overbucking and from the bottom up is underbucking.
With the "rip" tooth pattern, the edges are sharpened at right angles to the cutting plane, forming chisel-like cutting surfaces, whereas crosscut teeth are sharpened at an angle, so that each tooth has a knife-like cutting point in contact with the wood. [1]