Search results
Results from the WOW.Com Content Network
Water is mixed with sand and chemicals to create hydraulic fracturing fluid. Approximately 40,000 gallons of chemicals are used per fracturing. [84] A typical fracture treatment uses between 3 and 12 additive chemicals. [67] Although there may be unconventional fracturing fluids, typical chemical additives can include one or more of the following:
In the US, about 750 compounds have been listed as additives for hydraulic fracturing, also known as ingredients of pressurized fracking fluid, [9] in an industry report to the US Congress in 2011 [10] [11] The following is a partial list of the chemical constituents in additives that are used or may have been used in fracturing operations. [12]
Hydraulic fracturing is the propagation of fractures in a rock layer by pressurized fluid. Induced hydraulic fracturing or hydrofracking, commonly known as fracking, is a technique used to release petroleum, natural gas (including shale gas, tight gas and coal seam gas), or other substances for extraction, particularly from unconventional reservoirs. [1]
Environmental Protection Agency illustration of the water cycle of hydraulic fracturing. Fracking in the United States began in 1949. [1] According to the Department of Energy (DOE), by 2013 at least two million oil and gas wells in the US had been hydraulically fractured, and that of new wells being drilled, up to 95% are hydraulically fractured.
Hydraulic fracturing (fracking) and acidizing are two of the most common methods for well stimulation. These well stimulation techniques help create pathways for oil or gas to flow more easily, ultimately increasing the overall production of the well. [1] Well stimulation can be performed on an oil or gas well located onshore or offshore.
The Fracturing Responsibility and Awareness of Chemicals Act (later called the FRAC Act) was introduced to end the exemption of hydraulic fracturing practices from the Clean Water Act. This measure was proposed first in 2009 and later in 2011, however failed to pass in Congress on both occasions. [ 111 ]
Fracking fluids include proppants and other substances, which include chemicals known to be toxic, as well as unknown chemicals that may be toxic. [5] In the United States, such additives may be treated as trade secrets by companies who use them. Lack of knowledge about specific chemicals has complicated efforts to develop risk management ...
In the US, except for diesel-based additive fracturing fluids, noted by the American Environmental Protection Agency to have a higher proportion of volatile organic compounds and carcinogenic BTEX, use of fracturing fluids in hydraulic fracturing operations was explicitly excluded from regulation under the American Clean Water Act in 2005, a ...