Search results
Results from the WOW.Com Content Network
Verification is intended to check that a product, service, or system meets a set of design specifications. [6] [7] In the development phase, verification procedures involve performing special tests to model or simulate a portion, or the entirety, of a product, service, or system, then performing a review or analysis of the modeling results.
To establish a reference range, the Clinical and Laboratory Standards Institute (CLSI) recommends testing at least 120 patient samples. In contrast, for the verification of a reference range, it is recommended to use a total of 40 samples, 20 from healthy men and 20 from healthy women, and the results should be compared to the published reference range.
A test method is a method for a test in science or engineering, such as a physical test, chemical test, or statistical test. It is a definitive procedure that produces a test result. [ 1 ] In order to ensure accurate and relevant test results, a test method should be "explicit, unambiguous, and experimentally feasible.", [ 2 ] as well as ...
An example of a Levey–Jennings chart with upper and lower limits of one and two times the standard deviation. A Levey–Jennings chart is a graph that quality control data is plotted on to give a visual indication whether a laboratory test is working well. The distance from the mean is measured in standard deviations.
All analytical procedures should be validated. Identification tests are conducted to ensure the identity of an analyte in a sample through comparison of the sample to a reference standard through methods such as spectrum, chromatographic behavior, and chemical reactivity. [5] Impurity testing can either be a quantitative test or a limit test.
There are different reasons for performing a round-robin test: determination the reproducibility of a test method or process; verification of a new method of analysis. If a new method of analysis has been developed, a round-robin test involving proven methods would verify whether the new method produces results that agree with the established method.
For extremely specialised tests, samples may go to a research laboratory. Some tests involve specimens sent between different labs for uncommon tests. For example, in some cases it may be more cost effective if a particular laboratory specializes in a less common tests, receiving specimens (and payment) from other labs, while sending other ...
The model is viewed as an input-output transformation for these tests. The validation test consists of comparing outputs from the system under consideration to model outputs for the same set of input conditions. Data recorded while observing the system must be available in order to perform this test. [3]