Search results
Results from the WOW.Com Content Network
Thus, a measured NO x concentration of 45 ppmv (dry basis) in a gas having 5 volume % O 2 is 45 × ( 20.9 - 3 ) ÷ ( 20.9 - 5 ) = 50.7 ppmv (dry basis) of NO x when corrected to a gas having a specified reference O 2 content of 3 volume %.
When plotted in the manner described above, the value of the y-intercept (at = / =) will correspond to (), and the slope of the line will be equal to /. The values of y-intercept and slope can be determined from the experimental points using simple linear regression with a spreadsheet .
The following table lists the Van der Waals constants (from the Van der Waals equation) for a number of common gases and volatile liquids. [ 1 ] To convert from L 2 b a r / m o l 2 {\displaystyle \mathrm {L^{2}bar/mol^{2}} } to L 2 k P a / m o l 2 {\displaystyle \mathrm {L^{2}kPa/mol^{2}} } , multiply by 100.
The ideal gas equation can be rearranged to give an expression for the molar volume of an ideal gas: = = Hence, for a given temperature and pressure, the molar volume is the same for all ideal gases and is based on the gas constant: R = 8.314 462 618 153 24 m 3 ⋅Pa⋅K −1 ⋅mol −1, or about 8.205 736 608 095 96 × 10 −5 m 3 ⋅atm⋅K ...
This has the same form as an equation for a straight line: = +, where x is the reciprocal of T. So, when a reaction has a rate constant obeying the Arrhenius equation, a plot of ln k versus T −1 gives a straight line, whose slope and intercept can be used to determine E a and A respectively. This procedure is common in experimental chemical ...
The rectifying section operating line for the section above the inlet feed stream of the distillation column (shown in green in Figure 1) starts at the intersection of the distillate composition line and the x = y line and continues at a downward slope of L / (D + L), where L is the molar flow rate of reflux and D is the molar flow rate of the ...
Note that the especially high molar values, as for paraffin, gasoline, water and ammonia, result from calculating specific heats in terms of moles of molecules. If specific heat is expressed per mole of atoms for these substances, none of the constant-volume values exceed, to any large extent, the theoretical Dulong–Petit limit of 25 J⋅mol ...
The Avogadro constant, commonly denoted N A [1] or L, [2] is an SI defining constant with an exact value of 6.022 140 76 × 10 23 mol −1 (reciprocal moles). [3] [4] It defines the number of constituent particles in one mole, where the particles in question can be either molecules, atoms, ions, ion pairs, or any other elementary entities.