Ad
related to: do gold plated connectors make a difference in length calculator
Search results
Results from the WOW.Com Content Network
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Donate
The length of a sinusoidal wave is commonly expressed as an angle, in units of degrees (with 360° in a wavelength) or radians (with 2π radians in a wavelength). So alternately the electrical length can be expressed as an angle which is the phase shift of the wave between the ends of the conductor [1] [3] [5]
The MCX connector is also being used on at least some of the new generation of mostly inexpensive software-defined oscilloscopes and/or signal generators such as the DS212. This is a low frequency application, at most a few MHz bandwidth, so the electrical performance characteristics are relatively unimportant, however the small size would ...
A via, sometimes called PTV or plated-through-via, should not be confused with a plated through hole (PTH). A via is used as an interconnection between copper layers on a PCB while the PTH is generally made larger than vias and is used as a plated hole for acceptance of component leads - such as non-SMT resistors, capacitors, and DIP package IC.
Gold plated - gold layer thickness greater than or equal to 0.5 micron; Heavy gold plated / Vermeil - gold layer thickness greater than or equal to 2.5 micron; Gold plated silver jewellery can still tarnish as the silver atoms diffuse into the gold layer, causing slow gradual fading of its color and eventually causing tarnishing of the surface ...
Through-hole devices mounted on the circuit board of a mid-1980s home computer.Axial-lead devices are at upper left, while blue radial-lead capacitors are at upper right Close-up view of an electronic circuit board showing component lead holes (gold-plated) with through-hole plating up the sides of the hole to connect tracks on both sides of the board.
Boxes of jewellery wire. The left hand box has gold-plated, silver-plated and copper wire. The right hand box has reels of silver-plated wire at the top and reels of coloured copper wire at the bottom. Dead soft wire is extremely soft and pliable. It can be easily bent and is excellent for making rounded shapes such as spirals.
The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.
Ad
related to: do gold plated connectors make a difference in length calculator