enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hydraulic cylinder - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_cylinder

   A hydraulic cylinder is the actuator or "motor" side of this system. The "generator" side of the hydraulic system is the hydraulic pump which delivers a fixed or regulated flow of oil to the hydraulic cylinder, to move the piston. There are three types of pump widely used: hydraulic hand pump, hydraulic air pump, and hydraulic electric pump.

3. Hydraulic machinery - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_machinery

   The exterior is designed for abrasion resistance. The bend radius of hydraulic hose is carefully designed into the machine, since hose failures can be deadly, and violating the hose's minimum bend radius will cause failure. Hydraulic hoses generally have steel fittings swaged on the ends. The weakest part of the high pressure hose is the ...

4. List of components of oil drilling rigs - Wikipedia

   en.wikipedia.org/wiki/List_of_components_of_oil...

   Kelly hose (#9) is a flexible, high pressure hose that connects the standpipe to the kelly (or more specifically to the gooseneck on the swivel above the kelly) and allows free vertical movement of the kelly, while facilitating the flow of the drilling fluid through the system and down the drill string.

5. Blowout preventer - Wikipedia

   en.wikipedia.org/wiki/Blowout_preventer

   A typical subsea deepwater blowout preventer system includes components such as electrical and hydraulic lines, control pods, hydraulic accumulators, test valve, kill and choke lines and valves, riser joint, hydraulic connectors, and a support frame. Two categories of blowout preventer are most prevalent: ram and annular. BOP stacks frequently ...

6. Telescopic cylinder - Wikipedia

   en.wikipedia.org/wiki/Telescopic_cylinder

   The extension and retraction fluid supply ports on double acting hydraulic telescopic cylinders are usually located at opposite ends of the cylinder assembly. The extension port is mounted at the base of the outer barrel and the retraction port is mounted in the end of the plunger section.

7. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   A threaded pipe has a screw thread at one or both ends for assembly. Steel pipe is often joined with threaded connections; tapered threads are cut into the end of the pipe, and sealant is applied in the form of thread-sealing compound or thread seal tape (also known as PTFE or Teflon tape) and the pipe is screwed into a threaded fitting with a ...