enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Pulse-width modulation - Wikipedia

   en.wikipedia.org/wiki/Pulse-width_modulation

   PWM is useful for controlling the average power or amplitude delivered by an electrical signal. The average value of voltage (and current) fed to the load is controlled by switching the supply between 0 and 100% at a rate faster than it takes the load to change significantly. The longer the switch is on, the higher the total power supplied to ...

3. 0-10 V lighting control - Wikipedia

   en.wikipedia.org/wiki/0-10_V_lighting_control

   The switch is controlled by a PWM (Pulse Width Modulation) signal, which alternately turns the switch on and off at a rapid rate. The relative proportion of off time vs. on time determines brightness. For example, if the switch is off 10% of the time, the resulting control signal would be the equivalent of 1 V produced with a variable resistor.

4. Switching control techniques - Wikipedia

   en.wikipedia.org/wiki/Switching_Control_Techniques

   Fig. 2. EMI noise of output voltage for programmed switching frequency (PWM): a) Spectrum and b) Spectrogram. PWM is considered the most common deterministic technique. Considering the example of a DC-DC converter, a controlled switch is designed to “cut-off” the DC waveform into a pulse-shaped waveform.

5. Dimmer - Wikipedia

   en.wikipedia.org/wiki/Dimmer

   This circuit is called a leading-edge dimmer or forward phase dimming. Waveform of the output voltage of a thyristor dimmer set for 60 volts RMS output, with 120 V input. The red trace shows the output device switching on about 5.5 ms after the input (blue) voltage crosses zero.

6. Chopper (electronics) - Wikipedia

   en.wikipedia.org/wiki/Chopper_(electronics)

   For all the chopper configurations operating from a fixed DC input voltage, the average value of the output voltage is controlled by periodic opening and closing of the switches used in the chopper circuit. The average output voltage can be controlled by different techniques namely: Pulse-width modulation; Frequency modulation

7. Phase-fired controller - Wikipedia

   en.wikipedia.org/wiki/Phase-fired_controller

   The most common application is in dimmer switches for domestic lighting control. For industrial applications previously, extremely expensive and heavy multi-tapped transformers were used as the supplies for such elements, with the corresponding winding tap being connected to the element to produce the desired temperature. This limited the ...

8. Power management integrated circuit - Wikipedia

   en.wikipedia.org/wiki/Power_management...

   Power management integrated circuits (power management ICs or PMICs or PMU as unit) are integrated circuits for power management. Although PMIC refers to a wide range of chips (or modules in system-on-a-chip devices), most include several DC/DC converters or their control part.

9. Power electronics - Wikipedia

   en.wikipedia.org/wiki/Power_electronics

   AC/DC converters are used every time an electronic device is connected to the mains (computer, television etc.). These may simply change AC to DC or can also change the voltage level as part of their operation. AC/AC converters are used to change either the voltage level or the frequency (international power adapters, light dimmer).