Search results
Results from the WOW.Com Content Network
Some engine maintenance manuals refer to such systems as "customer bleed air". [3] [4] [5] Bleed air is valuable in an aircraft for two properties: high temperature and high pressure (typical values are 200–250 °C (400–500 °F) and 275 kPa (40 psi), for regulated bleed air exiting the engine pylon for use throughout the aircraft).
The bleed air comes from the engines but is bled from the engine upstream of the combustor. Air cannot flow backwards through the engine except during a compressor stall (essentially a jet engine backfire), thus the bleed air should be free of combustion contaminants from the normal running of the aircraft's own engines.
While modern engines with advanced control units can avoid many causes of stall, jet aircraft pilots must continue to take this into account when dropping airspeed or increasing throttle. A compressor anti-stall system is a compressor bleed system that automatically dumps away unwanted air to prevent compressor stalling. [5]
By the time the cold outside air has reached the bleed air valves, it has been heated to around 200 °C (392 °F). The control and selection of high or low bleed sources is fully automatic and is governed by the needs of various pneumatic systems at various stages of flight. Piston-engine aircraft require an additional compressor, see diagram ...
Captain Hunt believed the right engine was malfunctioning due to the smell of smoke in the cabin because in previous Boeing 737 variants bleed air for cabin air conditioning was taken from the right engine. Starting with the Boeing 737-400 variant, Boeing had redesigned the system to use bleed air from both engines.
The Pratt & Whitney J58 (company designation JT11D-20) is an American jet engine that powered the Lockheed A-12, and subsequently the YF-12 and the SR-71 aircraft. It was an afterburning turbojet engine with a unique compressor bleed to the afterburner that gave increased thrust at high speeds.
Some aircraft are equipped with pneumatic deicing boots that disperse ice build-up on the surface. These systems require less engine bleed air but are usually less effective than a heated surface. A few aircraft use a weeping wing system, which has hundreds of small holes in the leading edges and releases anti-icing fluid on demand to prevent ...
Bleed air systems are used by most large aircraft with jet engines or turboprops. Hot air is "bled" off one or more engines' compressor sections into tubes routed through wings, tail surfaces, and engine inlets. Spent air is exhausted through holes in the wings' undersides. A disadvantage of these systems is that supplying an adequate amount of ...