enow.com Web Search

  1. Ads

    related to: evaporative emission vent valve solenoid 2008 silverado

Search results

  1. Results from the WOW.Com Content Network
  2. Onboard refueling vapor recovery - Wikipedia

    en.wikipedia.org/wiki/Onboard_refueling_vapor...

    An onboard refueling vapor recovery system (ORVR) is a vehicle fuel vapor emission control system that captures volatile organic compounds (VOC, potentially harmful vapors) during refueling. [ 1 ] [ page needed ] There are two types of vehicle fuel vapor emission control systems: the ORVR, and the Stage II vapor recovery system. [ 2 ]

  3. Active Fuel Management - Wikipedia

    en.wikipedia.org/wiki/Active_Fuel_Management

    A solenoid control valve assembly integrated into the engine valley cover contains solenoid valves that provide a pressurized oil signal to specially designed hydraulic roller lifters provided by Eaton Corp. and Delphi. These lifters disable and re-enable exhaust and intake valve operation to deactivate and reactivate engine cylinders . Unlike ...

  4. Vehicle emissions control - Wikipedia

    en.wikipedia.org/wiki/Vehicle_emissions_control

    Evaporative emissions are the result of gasoline vapors escaping from the vehicle's fuel system. Since 1971, all U.S. vehicles have had fully sealed fuel systems that do not vent directly to the atmosphere; mandates for systems of this type appeared contemporaneously in other jurisdictions.

  5. Crankcase ventilation system - Wikipedia

    en.wikipedia.org/wiki/Crankcase_ventilation_system

    PCV valve on Ford Taunus V4 engine (feeding from left side valve cover into the inlet manifold) A crankcase ventilation system (CVS) removes unwanted gases from the crankcase of an internal combustion engine. The system usually consists of a tube, a one-way valve and a vacuum source (such as the inlet manifold).

  6. Early fuel evaporator - Wikipedia

    en.wikipedia.org/wiki/Early_fuel_evaporator

    The early fuel evaporator is a device found in some internal combustion engines with carburetors.It can sometimes be referred to as an electronic fuel evaporator. The device on a car, commonly referred to as an EFE heater, is located between the throttle body of the carburetor and the intake manifold as a gasket and contains a resistance grid that heats the air/fuel mixture.

  7. Secondary air injection - Wikipedia

    en.wikipedia.org/wiki/Secondary_air_injection

    A sensitive reed valve assembly called the aspirator valve is placed in the air injection pumping, which draws its air directly from the clean side of the air filter. During engine idle, brief but periodic negative pressure pulses in the exhaust system draw air through the aspirator valve and into the exhaust stream at the catalytic converter.

  8. Exhaust gas recirculation - Wikipedia

    en.wikipedia.org/wiki/Exhaust_gas_recirculation

    EGR valve the top of box on top of the inlet manifold of a Saab H engine in a 1987 Saab 90. In internal combustion engines, exhaust gas recirculation (EGR) is a nitrogen oxide (NO x) emissions reduction technique used in petrol/gasoline, diesel engines and some hydrogen engines. [1]

  9. Mitsubishi MCA - Wikipedia

    en.wikipedia.org/wiki/Mitsubishi_MCA

    Each MCA-Jet valve is quite small and may be prone to carbon build-up, causing the MCA-Jet valve(s) to stick open. If a Mitsubishi-designed engine has low compression, the MCA-Jet valve(s) could be the cause. Each MCA-Jet valve and valve seat are a self-contained cylinder-shaped unit that screws into the cylinder head for easy replacement.

  1. Ads

    related to: evaporative emission vent valve solenoid 2008 silverado