Search results
Results from the WOW.Com Content Network
When calculating a Thévenin-equivalent voltage, the voltage divider principle is often useful, by declaring one terminal to be V out and the other terminal to be at the ground point. The Thévenin-equivalent resistance R Th is the resistance measured across points A and B "looking back" into the circuit. The resistance is measured after ...
This is equivalent to calculating the Thevenin resistance. When there are dependent sources, the more general method must be used. The voltage at the terminals is calculated for an injection of a 1 ampere test current at the terminals. This voltage divided by the 1 A current is the Norton impedance R no (in ohms). This method must be used if ...
Source transformations are easy to compute using Ohm's law.If there is a voltage source in series with an impedance, it is possible to find the value of the equivalent current source in parallel with the impedance by dividing the value of the voltage source by the value of the impedance.
This is a particularly important transform for finding equivalent impedances. Its importance arises from the fact that the total impedance between two terminals cannot be determined solely by calculating series and parallel combinations except for a certain restricted class of network. In the general case additional transformations are required.
Simplified model for powering a load with resistance R L by a source with voltage V S and resistance R S.. The theorem was originally misunderstood (notably by Joule [4]) to imply that a system consisting of an electric motor driven by a battery could not be more than 50% efficient, since the power dissipated as heat in the battery would always be equal to the power delivered to the motor when ...
This impedance is termed the internal resistance of the source. When the power source delivers current , the measured voltage output is lower than the no- load voltage; the difference is the voltage drop (the product of current and resistance ) caused by the internal resistance.
Thévenin voltage source drives the circuit with Thévenin resistance . The output impedance of the amplifier is considered low enough that the relationship = is presumed to hold. At the output, serves as the load. (The load is irrelevant to this discussion: it just provides a path for the current to leave the circuit.)
The microcontroller's analog-to-digital converter is connected to the center tap of the divider so that it can measure the tap voltage and, by using the measured voltage and the known resistance and voltage, compute the sensor resistance. This technique is commonly used to measure the resistance of temperature sensors such as thermistors and RTDs.