Search results
Results from the WOW.Com Content Network
The shaft is the body of the stick, and is cylindrical for most applications including drum kit and orchestral work. It is used for playing cross stick and applied in a glancing motion to the rim of a cymbal for the loudest cymbal crashes. The butt is the opposite end of the stick to the tip. Some rock and metal musicians use it rather than the ...
Shaft angle. A shaft angle is the angle between the axes of two non-parallel gear shafts. In a pair of crossed helical gears, the shaft angle lies between the oppositely rotating portions of two shafts. This applies also in the case of worm gearing. In bevel gears, the shaft angle is the sum of the two
Drum sticks are beaters normally used in pairs, with each held in one hand, and are similar to or derived from the snare drum sticks that were subsequently adopted for kit drumming. They are the most general-purpose beaters, and the term covers a wide variety of beaters, but they are mainly used for untuned percussion.
Cross Stick: X notehead in the snare drum part. Rim Shot: diagonal slash through note head. Brush sweep: horizontal-line notehead, with a slur mark added to show that the brush is not lifted. (Together, the horizontal-line notehead and its stem look rather like a long "T" or a long inverted "T", depending which way the stem is going.)
Fulcrum is a drumming term. Traditionally, the fulcrum refers to the part of a percussionist's grip that is the main lever for the drum stick to rotate. [1] This is usually created by the thumb and index finger, the thumb and middle finger, or a combination of the thumb, index, and middle fingers.
The dimensions of the low pitch set of shells were the following (length mm, edge to edge): 810, 733, 667, 607. The high pitch set was dimensioned as follows: 552, 498, 455, 411 mm. All had a 6-inch diameter. In 1985 Tama modified the octobans by reducing the length of the shells.
Bachi for taiko drums. Drum bachi (桴, 枹) are made in a wide variety of sizes and materials, as appropriate to the drum it will be used to play.A typical bachi is about 22 mm (7/8 inches) in diameter, 400 mm (16 inches) long and made out of a hardwood such as oak.
Or, the note "F" on the piano staff is equal to the "bass drum." There is no set standard for writing drum music. But there is a guide that is usually adhered to. For example, in Steve Houghton's book Studio & Big Band Drumming, p. 9, under "Rock Patterns", Steve writes each drum or cymbal used in a percussion staff and states the assigned ...