Search results
Results from the WOW.Com Content Network
the fraction of the battery's capacity which is currently removed from the battery with regard to its (fully) charged state. For fully charged batteries, the depth of discharge is connected to the state of charge by the simple formula =. The depth of discharge then is the complement of state of charge: as one increases, the other decreases.
Most rifle cartridges have a high load density with the appropriate powders. Rifle cartridges tend to be bottlenecked, with a wide base narrowing down to a smaller diameter, to hold a light, high-velocity bullet. These cases are designed to hold a large charge of low-density powder, for an even broader pressure curve than a magnum pistol cartridge.
State of charge (SoC) quantifies the remaining capacity available in a battery at a given time and in relation to a given state of ageing. [1] It is usually expressed as percentage (0% = empty; 100% = full). An alternative form of the same measure is the depth of discharge , calculated as 1 −
Free recoil / Frecoil is a vernacular term or jargon for recoil energy of a firearm not supported from behind. Free recoil denotes the translational kinetic energy (E t) imparted to the shooter of a small arm when discharged and is expressed in joules (J), or foot-pound force (ft·lb f) for non-SI units of measure.
Example of a ballistic table for a given 7.62×51mm NATO load. Bullet drop and wind drift are shown both in mrad and MOA.. A ballistic table or ballistic chart, also known as the data of previous engagements (DOPE) chart, is a reference data chart used in long-range shooting to predict the trajectory of a projectile and compensate for physical effects of gravity and wind drift, in order to ...
The KiBaM battery model [3] describes the recovery effect for lead-acid batteries and is also a good approximation to the observed effects in Li-ion batteries. [1] [4] In some batteries, the gains from the recovery life can extend battery life by up to 45% by alternating discharging and inactive periods rather than constantly discharging. [5]
For example, consider a battery with a capacity of 200 Ah at the C 20 rate (C 20 means the 20-hour rate – i.e. the rate that will fully discharge the battery in 20 hours – which in this case is 10 A). If this battery is discharged at 10 A, it will last 20 hours, giving the rated capacity of 200 Ah.
From a thermodynamic point of view, a firearm is a special type of piston engine, or in general heat engine where the bullet has a function of a piston. The energy conversion efficiency of a firearm strongly depends on its construction, especially on its caliber and barrel length.