Search results
Results from the WOW.Com Content Network
This type of mesh is a square grid of uniformly placed wires, welded at all intersections, and meeting the requirements of ASTM A185 and A497 or other standards. [1] The sizes are specified by combining the spacing, in inches or mm, and the wire cross section area in hundredths of square inches or mm2.
Wire decking consists of wire mesh supported by metal supports and is intended to be load-bearing. The mesh is usually welded to the supports, but may be attached in other ways as well. In commercial and industrial applications, the wire mesh usually has a minimum wire gauge of 0.105 inches when round wire is used. The most common shelf size is ...
Wire gauze or wire mesh is a gauze woven of metal wire, or very fine, gauze-like wire netting. Wire gauze is placed on the support ring that is attached to the retort stand between a burner and glassware , or is placed on a tripod to support beakers , flasks , or other glassware to protect it during heating.
Welded wire mesh fence is a steel fence consisting of wire strands electrically welded together to form a high strength mesh. The fencing is available in two formats: rolled mesh and rigid mesh. Over the last 30 years rigid mesh fencing has become the system of choice for demarcation across the UK, Europe and Australia.
Mesh is a measurement of particle size often used in determining the particle-size distribution of a granular material. For example, a sample from a truckload of peanuts may be placed atop a mesh with 5 mm openings. When the mesh is shaken, small broken pieces and dust pass through the mesh while whole peanuts are retained on the mesh.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Cable trays are used as an alternative to open wiring or electrical conduit systems, and are commonly used for cable management in commercial and industrial construction. They are especially useful in situations where changes to a wiring system are anticipated, since new cables can be installed by laying them in the tray, instead of pulling ...
The name of the antenna describes its shape: A metal disk above a metal cone. The cone points upwards and is made of solid metal, wire mesh, or a skirt of about a dozen sloping wires that outline a cone. The cone measures near one quarter-wave long along the side from tip to bottom rim, at the antenna's lowest frequency.