enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. UHF connector - Wikipedia

   en.wikipedia.org/wiki/UHF_connector

   The connector reliably carries signals at frequencies up to 100 MHz. [1] The coupling shell has a ⁠ 5 / 8 ⁠ inch 24 tpi UNEF standard thread. [4] The most popular cable plug and corresponding chassis-mount socket carry the old Signal Corps labels PL-259 (plug #259) and SO-239 (socket #239). [12]

3. List of RF connector types - Wikipedia

   en.wikipedia.org/wiki/List_of_RF_connector_types

   LEMO 00 connector, a proprietary push-pull 50 Ω coaxial connector; MCX connector; Microdot S-50 series connector, a proprietary 50 Ω coaxial connector; Mini-BNC connector; Mini-UHF connector, a smaller and much newer design than the standard UHF; SMA connector A 50 ohm screwed connection. The 0.9mm centre pin is the same diameter as the ...

4. Talk:UHF connector - Wikipedia

   en.wikipedia.org/wiki/Talk:UHF_connector

   The connectors used for video purposes were standard PL259 connectors. Contrast the BNC connector which is a constant impedance connector and did exist in both 50 and ...

5. List of video connectors - Wikipedia

   en.wikipedia.org/wiki/List_of_video_connectors

   Replaced by F connector in North America and Belling-Lee Connector in other countries outside North America. UHF connector (e.g. PL-259/SO-239) Despite its name, now most commonly seen on higher-power HF radio equipment, e.g. SSB transceivers. A popular choice for amateur radio enthusiasts. 50 Ω

6. BNC connector - Wikipedia

   en.wikipedia.org/wiki/BNC_connector

   Typically the male connector is fitted to a cable, and the female to a panel on equipment. Cable connectors are often designed to be fitted by crimping [9] using a special power or manual tool. [10] [failed verification] Wire strippers which strip outer jacket, shield braid, and inner dielectric to the correct lengths in one operation are used ...

7. N connector - Wikipedia

   en.wikipedia.org/wiki/N_connector

   The male connector is hand-tightened (though versions with a hex nut are also available) and has an air gap between the center and outer conductors. The coupling has a ⅝-24 UNEF thread . Amphenol suggests tightening to a torque of 15 inch-pounds (1.7 N⋅m), [ 2 ] while Andrew Corporation suggest 20 inch-pounds (2.3 N⋅m) for their hex nut ...