Search results
Results from the WOW.Com Content Network
The most common usage is the DB25, using TASCAM's pinout (now standardised in AES59 by the Audio Engineering Society [1]). To avoid the possibility of bent pins on fixed equipment, the male connector is generally fitted to the cabling and the female connector to the equipment.
An IEEE 1284 36-pin female on a circuit board. In the 1970s, Centronics developed the now-familiar printer parallel port that soon became a de facto standard.Centronics had introduced the first successful low-cost seven-wire print head [citation needed], which used a series of solenoids to pull the individual metal pins to strike a ribbon and the paper.
For example, DB-25 denotes a D-sub with a 25-position shell size and a 25-position contact configuration. The contacts in each row of these connectors are spaced 326/3000 of an inch apart, or approximately 0.1087 inches (2.76 mm), and the rows are spaced 0.112 inches (2.84 mm) apart; the pins in the two rows are offset by half the distance ...
Mini-Centronics 36-pin male connector (top) with Micro ribbon 36-pin male Centronics connector (bottom) The Apple II Parallel Printer Port connected to the printer via a folded ribbon cable; one end connected to the connector at the top of the card, and the other end had a 36-pin Centronics connector.
Old Macintosh DB-25 SCSI port (narrow) Apple used DB-25 connectors, which, having only 25 pins rather than 50, were smaller and less expensive to make, but decreased signal integrity (increasing crosstalk) [citation needed] and cannot be used with differential signaling. Furthermore, DB-25s were commonly used for RS-232 serial cables and also ...
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
A DB-25 connector as described in the RS-232 standard Data circuit-terminating equipment (DCE) and data terminal equipment (DTE) network. In telecommunications, RS-232 or Recommended Standard 232 [1] is a standard originally introduced in 1960 [2] for serial communication transmission of data.
Ribbon cable with three connectors. Ribbon cables are usually specified by two numbers: the spacing or pitch of the conductors, and the number of conductors or ways. A spacing of 0.05 inch (1.27 mm) is the most usual, allowing for a two-row connector with a pin spacing of 0.1 inch (2.54 mm).