Search results
Results from the WOW.Com Content Network
is the rolling resistance coefficient or coefficient of rolling friction with dimension of length, and N {\displaystyle N} is the normal force (equal to W , not R , as shown in figure 1). The above equation, where resistance is inversely proportional to radius r {\displaystyle r} seems to be based on the discredited "Coulomb's law" (Neither ...
The friction coefficient is an empirical (experimentally measured) structural property that depends only on various aspects of the contacting materials, such as surface roughness. The coefficient of friction is not a function of mass or volume. For instance, a large aluminum block has the same coefficient of friction as a small aluminum block.
Traction can also refer to the maximum tractive force between a body and a surface, as limited by available friction; when this is the case, traction is often expressed as the ratio of the maximum tractive force to the normal force and is termed the coefficient of traction (similar to coefficient of friction).
This theory is exact for the situation of an infinite friction coefficient in which case the slip area vanishes, and is approximative for non-vanishing creepages. It does assume Coulomb's friction law, which more or less requires (scrupulously) clean surfaces. This theory is for massive bodies such as the railway wheel-rail contact.
Frictional contact mechanics emphasizes the effect of friction forces. Contact mechanics is part of mechanical engineering . The physical and mathematical formulation of the subject is built upon the mechanics of materials and continuum mechanics and focuses on computations involving elastic , viscoelastic , and plastic bodies in static or ...
The former is concerned with static friction (also known as "stiction" [3]) or "limiting friction", whilst the latter is dynamic friction, also called "sliding friction". For steel on steel, the coefficient of friction can be as high as 0.78, under laboratory conditions, but typically on railways it is between 0.35 and 0.5, [ 4 ] whilst under ...
These coefficients are measured on rollers, with power meters on road surfaces, or with coast-down tests. In the latter two cases, the effect of air resistance must be subtracted or the tests performed at very low speeds. In 2009 The CEC used a rating called Rolling Resistance Force RRF. RRF and RRC, rolling resistance coefficient are very similar.
rolling friction. In the case of bodies capable of rolling, there is a particular type of friction, in which the sliding phenomenon, typical of dynamic friction, does not occur, but there is also a force that opposes the motion, which also excludes the case of static friction. This type of friction is called rolling friction.