Ads
related to: muncie 318 input shaft bearing 2003 toyota matrix manual transmissionwalmart.com has been visited by 1M+ users in the past month
carparts.com has been visited by 10K+ users in the past month
ebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
The Muncie SM420 is a heavy duty, four-speed manual transmission that was produced from 1947 to 1967 by General Motors for civilian use in a variety of pickup trucks, buses, dump trucks and heavy equipment. They were used in some military vehicles into the 1980s. It was replaced in civilian vehicles by the Muncie SM465 transmission in 1968.
The Matrix was first introduced in the 2003 model year and based on the Toyota Corolla platform. [6] Relatively unchanged in 2004, a facelift for 2005 brought minor revisions to the exterior – mainly revised styling to the front fascia due to complaints of rubbing the ground on the previous incarnation and replacing the red lenses on the taillamps with clear ones.
There have been three different output shafts for pickup trucks. Early four-wheel drive was a short 10 spline. Later, a 35-spline version was for 2 wheel drive, whereas 4WD units had a 32-spline output shaft. [1] The SM465 was the only manual transmission available for 1988-1991 R/V-series trucks and SUVs. [citation needed]
Saginaw M26/27 transmission — 3 and 4-speed longitudinal light duty (less than 300 hp) wide ratio manual transmission made by GM at their Saginaw, Michigan factory; Muncie M62/M64 — 3-speed longitudinal transmission made by GM; Muncie SM318 transmission — 3-speed transmission used from 1954 through 1969 in both passenger car and truck ...
The J-series is a 6-speed manual transmission for rear-wheel drive applications, built by Aisin Seiki (Type AZ6). This transmission was used in the Altezza AS200 and RS200. The same Aisin AZ6 transmission is also found in other models such as the Mazda MX-5 (Miata), Nissan Silvia, Mazda RX-8, Lexus IS and Toyota 86/Scion FR-S/Subaru BRZ. Models:
In February 2002, General Motors sold its minority 36% stake in the New Venture Gear company to DaimlerChrysler and the Muncie Transmission plant reverted to GM control. [6] GM changed the plant name to "Manual Transmissions of Muncie." The T.W. Warner Muncie plant closed in mid-2006 after a century of operation and the property was turned over ...
Ads
related to: muncie 318 input shaft bearing 2003 toyota matrix manual transmissionwalmart.com has been visited by 1M+ users in the past month
carparts.com has been visited by 10K+ users in the past month
ebay.com has been visited by 1M+ users in the past month