enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Underground hard-rock mining - Wikipedia

    en.wikipedia.org/wiki/Underground_hard-rock_mining

    Cut and fill mining is a method of short-hole mining used in steeply dipping or irregular ore zones, in particular where the hanging wall limits the use of long-hole methods. The ore is mined in horizontal or slightly inclined slices, and then filled with waste rock, sand or tailings. Either fill option may be cemented with binders to add ...

  3. Room and pillar mining - Wikipedia

    en.wikipedia.org/wiki/Room_and_pillar_mining

    Room and pillar mining was one of the earliest methods used, [3] although with significantly more manpower. The room and pillar system is used in mining coal , gypsum , [ 4 ] iron , [ 5 ] limestone , [ 6 ] and uranium [ 7 ] ores, particularly when found as manto or blanket deposits, stone and aggregates , talc , soda ash , and potash . [ 8 ]

  4. Cut and fill - Wikipedia

    en.wikipedia.org/wiki/Cut_and_fill

    A mass haul diagram where land and rock cuts are hauled to fills Fill construction in 1909 Cut & Fill Software showing cut areas highlighted in red and fill areas shaded in blue. In earthmoving , cut and fill is the process of constructing a railway , road or canal whereby the amount of material from cuts roughly matches the amount of fill ...

  5. Hydraulic fill - Wikipedia

    en.wikipedia.org/wiki/Hydraulic_fill

    Hydraulic fill is likely to be the most economic method of construction. Even when the source material lacks sufficient elevation, it can be elevated to the sluice by a dredge pump. In the construction of a hydraulic fill dam, the edges of the dam are defined by low embankments or dykes which are built upward as the fill progresses. The sluices ...

  6. Lucky Friday mine - Wikipedia

    en.wikipedia.org/wiki/Lucky_Friday_mine

    The mining method used is underhand cut and fill mining. [ 3 ] The mine's primary access and production are through the Silver Shaft, an 18-foot (5.5 m) diameter, concrete-lined shaft sunk to a depth of 6,200 feet (1,890 m), [ 4 ] [ 5 ] [ 6 ] over 2,800 feet (855 m) below sea level .

  7. Stoping - Wikipedia

    en.wikipedia.org/wiki/Stoping

    In shrinkage stoping, mining proceeds from the bottom upwards, in horizontal slices (similar to cut and fill mining), with the broken ore being left in place for miners to work from. Because blasted rock takes up a greater volume than in situ rock (due to swell factor ), some of the blasted ore (approximately 40%) must be removed to provide ...

  8. AOL Mail

    mail.aol.com

    Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

  9. Bucket-wheel excavator - Wikipedia

    en.wikipedia.org/wiki/Bucket-wheel_excavator

    Bucket-wheel excavators have been used in mining for the past century, with some of the first being manufactured in the 1920s. [1] They are used in conjunction with many other pieces of mining machinery (conveyor belts, spreaders, crushing stations, heap-leach systems, etc.) to move and mine massive amounts of overburden (waste). While the ...