Search results
Results from the WOW.Com Content Network
Using a vernier caliper to take measurements on a nut. The 1st two digits are decided by the location of the 0 on the lower scale. The last digit is determined by the 1st line on the lower scale that exactly matches the upper scale.
Vernier caliper scales; main at top, vernier at bottom. It reads 3.58 ± 0.02 mm by adding 3.00 mm (left red mark) on the fixed main scale to vernier 0.58 mm (right red mark). The main scale reading is that to the left of the zero on the vernier scale. The vernier reading is found by locating the best aligned lines between the two scales.
Instead of using a vernier mechanism, which requires some practice to use, the dial caliper reads the final fraction of a millimeter or inch on a simple dial. In this instrument, a small, precise rack and pinion drives a pointer on a circular dial , allowing direct reading without the need to read a vernier scale.
The dieter's problem: this scale can only resolve weight changes of 0.2 lbs, even though the digital display looks as if it could show 0.1 In the science of measurement , the least count of a measuring instrument is the smallest value in the measured quantity that can be resolved on the instrument's scale. [ 1 ]
Here the metric scale shows a distance of 2.475 cm between the jaw faces: the 0 mark on the vernier is between 2.4 and 2.5, and the 7.5 mark is the one best aligned with a mark on the main scale. Similarly, the inch scale shows (15 5 / 8 )/16, or 125/128, of an inch.
[4] [5] Vernier acuity was first explained by Ewald Hering in 1899, [6] based on earlier data by Alfred Volkmann in 1863 [7] and results by Ernst Anton Wülfing in 1892. [8] Vernier acuity is resistant to defocus, motion, and luminance, but is subject to practice effects and changes in attention. [3]
The main scale reading is the rightmost graduation that is to the left of the zero on the vernier scale. The vernier reading is found by locating the best aligned lines between the two scales. The 0.02 mm engraving indicates the caliper's accuracy and is the "Vernier constant" for this scale. He was born in Ornans, France, in 1580. He was ...
Vernier micrometer reading 5.783 ± 0.001 mm, comprising 5.5 mm on main screw lead scale, 0.28 mm on screw rotation scale, and 0.003 mm added from vernier. Some micrometers are provided with a vernier scale on the sleeve in addition to the regular graduations. These permit measurements within 0.001 millimetre to be made on metric micrometers ...