Ads
related to: what is a engine compression test
Search results
Results from the WOW.Com Content Network
Compression tests should normally be done with all spark plugs removed to maximize cranking speed. Cranking compression is a dynamic test of the actual low-speed pumping action, where peak cylinder pressure is measured and stored. A compression tester. Leak-down testing is a static test. Leak-down tests cylinder leakage paths.
In piston engines, static compression ratio is determined using the cylinder volume when the piston is at the top and bottom of its travel. The compression ratio is the ratio between the maximum and minimum volume during the compression stage of the power cycle in a piston or Wankel engine.
Variable compression ratio (VCR) is a technology to adjust the compression ratio of an internal combustion engine while the engine is in operation. This is done to increase fuel efficiency while under varying loads. Variable compression engines allow the volume above the piston at top dead centre to be changed. Higher loads require lower ratios ...
In mechanics, compressive strength (or compression strength) is the capacity of a material or structure to withstand loads tending to reduce size (compression). It is opposed to tensile strength which withstands loads tending to elongate, resisting tension (being pulled apart).
During the compression stroke of an internal combustion engine, the temperature of the air-fuel mix rises as it is compressed, in accordance with the ideal gas law. Higher compression ratios necessarily add parasitic load to the engine, and are only necessary if the engine is being specifically designed to run on high-octane fuel.
In aeronautical engineering, overall pressure ratio, or overall compression ratio, is the amount of times the pressure increases due to ram compression and the work done by the compressor stages. The compressor pressure ratio is the ratio of the stagnation pressures at the front and rear of the compressor of a gas turbine .
This type of compressor is used in gas turbine engines, for supercharging reciprocating engines and for industrial processes, where it is known as a dynamic compressor. A map is created from compressor rig test results or predicted by a special computer program. Alternatively the map of a similar compressor can be suitably scaled.
The most common kind of small engine compression release uses a camshaft mounted mechanical lever that pushes the exhaust valve tappet slightly, venting engine compression through the exhaust valve. Once the engine spins to starting speed, centrifugal force causes the lever to move out of the way, and the exhaust valve is allowed to seat fully.
Ads
related to: what is a engine compression test