Search results
Results from the WOW.Com Content Network
— "Values ranging from 21.3 to 21.5 gm/cm 3 at 20 °C have been reported for the density of annealed platinum; the best value being about 21.45 gm/cm 3 at 20 °C." 21.46 g/cm 3 — Rose, T. Kirke. The Precious Metals, Comprising Gold, Silver and Platinum .
High grade and ultra high grade anthracite are harder than standard grade anthracite, and have a higher relative density. An example of a chemical formula for high-grade anthracite would be C 240 H 90 O 4 NS, [25] representing 94% carbon. [26] UHG anthracite typically has a minimum carbon content of 95%.
The kilogram per cubic metre (symbol: kg·m −3, or kg/m 3) is the unit of density in the International System of Units (SI). It is defined by dividing the SI unit of mass, the kilogram, by the SI unit of volume, the cubic metre. [1]
This is tested in a calibrated mill, containing four blades of known mass. The coal is agitated in the mill for 12,000 revolutions at a rate of 1,500 revolutions per minute.(I.E 1500 revolution for 8 min.) The abrasion index is determined by measuring the loss of mass of the four metal blades.
For example when defining unit code m2 put SI2 here, and for m3 say SI3. This will scale, for example, km2 to 1000 × 1000 of the base unit, m , or scale mm3 to 0.001 × 0.001 × 0.001 of the base unit m .
In all, the higher heating value of hydrogen is 18.2% above its lower heating value (142 MJ/kg vs. 120 MJ/kg). For hydrocarbons, the difference depends on the hydrogen content of the fuel. For gasoline and diesel the higher heating value exceeds the lower heating value by about 10% and 7%, respectively, and for natural gas about 11%.
In general. Usually parameters reproduce the value, and the template adds the SI unit or additional standard text. While the topic is technical, we can strive to make the result readable text, and even verbose.
50 g of air dried coal featuring a grain size in the range between 0.6 and 1.18 mm are filled into the sample mill and a weight is put on the mill's grinding stone. After 60 rounds the grinded coal is put on a sampling sieve. Factor D equals the fraction of the coal passing through the sieve of 74 μm corresponding to 200 mesh.