Search results
Results from the WOW.Com Content Network
In pin tumbler locks, the series of key cuts on a key causes the pins to line up at the shear line or gate so the lock will open. In warded locks, the key cuts bypass the wards so the key can push or pull the bolt. [6] Key pin In a pin tumbler lock, the key pin is in contact with the key. It has varying lengths, corresponding to the key's ...
In the early 1920s, Harry Soref started Master Lock off with the first laminated padlock. Plates that were punched from sheet metal were stacked and assembled. Holes that were formed in the middle of the plates made room to accommodate the locking mechanism. The entire stack of plates, loaded with the lock parts in it, was riveted together.
A practical attack exists to create a working master key for an entire system given only access to a single master-keyed lock, its associated change key, a supply of appropriate key blanks, and the ability to cut new keys. [2] Locksmiths may also determine cuts for a replacement master key, when given several different key examples from a given ...
Many combination locks have three wheels, but the lock may be equipped with additional wheels, each with a drive pin and fly, in a similar manner. The number of wheels in the mechanism determines the number of specific dial positions that must be entered to open the lock, so a three-sequence combination is required for a three-wheel lock.
The Chubb detector lock is a variation of the lever lock which was designed to detect and prevent picking attempts. Lever locks can be drilled, but usually a template or stencil is required to mark the drilling point, as the lock mechanism is commonly mortised into the door and so it is harder to determine the point at which to drill.
The normal key on the left will open only the lock that it goes to, but the skeleton key on the right will open any lock with this particular keyhole. Two warded lock keys and a homemade skeleton key. A skeleton key (also known as a passkey [1]) is a type of master key in which the serrated edge has been removed in such a way that it can open ...
The key design is a U-shape profile with six cuts on each side of the key, along with a central roller to activate the trigger pin in the front and center of the cylinder. [ 1 ] In order for the lock to operate, the key must be fully inserted, allowing the dual sidebars to enter the pins, provided the pins were raised to the correct height ...
In Europe, many small puzzle padlocks had front plate with a face or mask. The padlocks were designed to secure small bags or pouches and could be found across Europe with the most around the Danubian provinces and Aquileia. [2] They were often shaped like rings and may have been fitted around the mouth of a bag as a sort of tamper-proof seal. [3]