enow.com Web Search

  1. Ads

    related to: wire test lights led circuit board

Search results

  1. Results from the WOW.Com Content Network
  2. Test light - Wikipedia

    en.wikipedia.org/wiki/Test_light

    A test light, test lamp, voltage tester, or mains tester is a piece of electronic test equipment used to determine the presence of electricity in a piece of equipment under test. A test light is simpler and less costly than a measuring instrument such as a multimeter , and often suffices for checking for the presence of voltage on a conductor.

  3. LED circuit - Wikipedia

    en.wikipedia.org/wiki/LED_circuit

    The circuit must provide sufficient current to light the LED at the required brightness, but must limit the current to prevent damaging the LED. The voltage drop across a lit LED is approximately constant over a wide range of operating current; therefore, a small increase in applied voltage greatly increases the current.

  4. Continuity test - Wikipedia

    en.wikipedia.org/wiki/Continuity_test

    In electronics, a continuity test is the checking of an electric circuit to see if current flows (that it is in fact a complete circuit). A continuity test is performed by placing a small voltage (wired in series with an LED or noise-producing component such as a piezoelectric speaker ) across the chosen path.

  5. Continuity tester - Wikipedia

    en.wikipedia.org/wiki/Continuity_tester

    The indicator may be an electric light or a buzzer. [1] This led to the term "buzzing out a circuit" (which means to test for continuity) [3] Audible continuity buzzers or beepers are built into some models of multimeter, and the continuity setting is normally shared with the ohmmeter setting.

  6. Reference designator - Wikipedia

    en.wikipedia.org/wiki/Reference_designator

    A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.

  7. Electrical outlet tester - Wikipedia

    en.wikipedia.org/wiki/Electrical_outlet_tester

    A receptacle tester being used to check for some types of improper wiring of an outlet. For this particular tester, proper wiring is indicated by the two yellow lights. The outlet tester checks that each contact in the outlet appears to be connected to the correct wire in the building's electrical wiring. It can identify several common wiring ...

  1. Ads

    related to: wire test lights led circuit board