Search results
Results from the WOW.Com Content Network
The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...
Black-Light Blue lamps: These lamps are similar to the regular black light lamps, except they use wood's glass as a filter to reduce the amount of visible light emitted. These lamps are used for fluorescence effects where less visible light is ideal. 09 N/A Sun-tanning lamps: These lamps produce wide or narrow band UV-B radiation 10 BL Black ...
The GU24 fitting is intended to maintain the energy efficiency of the light by preventing an occupant from using an incandescent bulb instead of a CFL. Adapters to use incandescent bulbs in a GU24 fitting are illegal in the State of California as they would be a fire hazard in fixtures designed for the lower heat output of a CFL bulb. [2]
Incandescent light bulbs consist of an air-tight glass enclosure (the envelope, or bulb) with a filament of tungsten wire inside the bulb, through which an electric current is passed. Contact wires and a base with two (or more) conductors provide electrical connections to the filament.
GY6.35 & GZ6.35 – same as G6.35 and only denote what lamp mount clip is needed to hold the actual light bulb in place; G8 – 8 mm (0.31496 in) pin spacing GU8 – same as G8 and only denotes what lamp mount clip is needed to hold the actual light bulb in place; GY8.6 – 8.6 mm (0.33858 in) pin spacing; G9 – 9 mm (0.35433 in) pin spacing
Left to right: MR16 with GU10 base, MR16 with GU5.3 base, MR11 with GU4 or GZ4 base Line drawing of an LED MR16 lamp, with a heatsink rather than a reflector. A multifaceted reflector (often abbreviated MR) light bulb is a reflector housing format for halogen as well as some LED and fluorescent lamps.
The wires are usually inserted into a plastic base that the bulb is mounted in, and which is often narrower at the tip than at the bulb, giving it a wedge shape and usually ensuring a tight connection, depending on manufacturing tolerances. Some bulbs have no plastic base, and the wires are simply bent up to the sides of the bulb's glass base.
By the 1927 revision of BS 73 four sizes of two-pin plugs and sockets were standardized: 2 A, 5 A, 15 A and 30 A. This was later superseded by BS 372:1930 part 1 Two-pin Side-entry Wall Plugs And Sockets for Domestic Purposes. Following the introduction of BS 4573 in 1970 there were no longer any UK domestic uses for two-pin sockets except for ...