enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   Spindle nose on a lathe headstock. The small female taper is a Morse taper to take a lathe center or a tool such as a twist drill. The large male taper takes a lathe chuck, which is retained by the large nut. A machine taper is a system for securing cutting tools or toolholders in the spindle of a machine tool or power tool.

3. Drawbar force gauge - Wikipedia

   en.wikipedia.org/wiki/Drawbar_Force_Gauge

   The following tool holder standards specifically address tool retention force as measured by a drawbar force gauge: HSK standard ISO 12164-1: Hollow taper interface with flange contact surface—Part 1: Shanks—Dimensions; Steep Taper standard ASME B5.50: 7/24 Taper Tool to Spindle Connection for Automatic Tool Change

4. Reamer - Wikipedia

   en.wikipedia.org/wiki/Reamer

   No. 3 morse taper reamer. A morse taper reamer is used manually to finish morse taper sleeves. These sleeves are a tool used to hold machine cutting tools or holders in the spindles of machines such as a drill or milling machine. The reamer shown is a finishing reamer.

5. Game of the Day: WordChuck - AOL

   www.aol.com/news/2014-08-06-game-of-the-day-word...

   How many words can a woodchuck chuck if he could chuck words? Well you're the WordChuck in today's Game of the Day! From the makers of Just Words comes WordChuck, a multiplayer game that delivers ...

6. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   The chuck may be held against the taper with a threaded retainer ring (large thin nut), typically wrenched with a spanner wrench of the pin or hook variety. The peak of popularity for building this type of spindle nose was the 1940s and 1950s. The chuck may be held against the taper with cam-lock posts that wedge into a stuck-fast position.

7. Robertson screw - Wikipedia

   en.wikipedia.org/wiki/Robertson_screw

   Both the tool and socket have a slight taper. The contemporary square drive screw has all but replaced the Robertson screw proper and is commonly referred to as a Robertson because it has practically identical drive dimensions and the same colour identification system, but the contemporary square drive socket has parallel sides rather than tapered.