Search results
Results from the WOW.Com Content Network
The Westinghouse Combustion Turbine Systems Division (CTSD), part of Westinghouse Electric Corporation's [1] Westinghouse Power Generation [2] group, was originally located, along with the Steam Turbine Division (STD), in a major industrial manufacturing complex, referred to as the South Philadelphia Works, in Lester, Pennsylvania near to the Philadelphia International Airport.
Westinghouse pump (US+) Powered by steam, it compresses air for operating the train air brake system. [3]: 2 The Westinghouse air brake system is used world-wide; [3]: 93 in Europe two systems that use the same principle are the Kunze-Knorr and Oerlikon systems. It can be a single-stage or, when larger capacity is needed, a two-stage cross ...
In addition, Westinghouse produced and supplied electrical and traction equipment for Baldwin diesel locomotives from 1939 to 1955 and Lima-Hamilton diesels from 1949-1951 until production at Lima, Ohio ended with the merger into Baldwin. Fairbanks-Morse diesels also used Westinghouse electrical and traction equipment.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Steam turbine generator: The first commercial Westinghouse steam turbine-driven generator, a 1,500 kW unit, began operation at Hartford Electric Light Co. in 1901. The machine, nicknamed Mary-Ann, was the first steam turbine generator to be installed by an electric utility to generate electricity in the US.
This generator weights 1,140,000 lbs and is a record shipment for the Railroad at that time (1970). A once-through steam generator A VVER steam generator. Westinghouse and Combustion Engineering designs have vertical U-tubes with inverted tubes for the primary water. Canadian, Japanese, French, and German PWR suppliers use the vertical ...
The bearings have to be leak-tight. A hermetic seal, usually a liquid seal, is employed; a turbine oil at pressure higher than the hydrogen inside is typically used. A metal, e.g. brass, ring is pressed by springs onto the generator shaft, the oil is forced under pressure between the ring and the shaft; part of the oil flows into the hydrogen side of the generator, another part to the air side.
The rotor of a turbo generator is a non-salient pole type usually with two poles. [5] The normal speed of a turbo generator is 1500 or 3000 rpm with four or two poles at 50 Hz (1800 or 3600 rpm with four or two poles at 60 Hz). The rotating parts of a turbo generator are subjected to high mechanical stresses because of the high operation speed.