Search results
Results from the WOW.Com Content Network
The main advantage of the reverse-flow cylinder head is that both the entering inlet charge and the exiting exhaust gas cause a tendency to swirl in the same direction in the combustion chamber. [1] In a crossflow head the inlet and exhaust gases promote swirl in opposite directions so that during overlap the swirl changes directions.
If coolant flow is restricted, heating capacity will be reduced or even lost altogether if the heater core becomes blocked. Control valves may also clog or get stuck. Where a blend door is used instead of a control valve as a method of controlling the air's heating amount, the door itself or its control mechanism can become stuck due to thermal ...
Most modern internal combustion engines are cooled by a closed circuit carrying liquid coolant through channels in the engine block and cylinder head. A fluid in these channels absorbs heat and then flows to a heat exchanger or radiator where the coolant releases heat into the air (or raw water, in the case of marine engines).
Cooling system regulation includes adjustable baffles in the air flow (sometimes called 'shutters' and commonly run by a pneumatic 'shutterstat'); a fan which operates either independently of the engine, such as an electric fan, or which has an adjustable clutch; and a thermostatic valve or a thermostat that can block the coolant flow when too ...
Once the coolant absorbs the heat from the engine it continues its flow to the radiator. The radiator transfers heat from the coolant to the passing air. Radiators are also used to cool automatic transmission fluids , air conditioner refrigerant , intake air , and sometimes to cool motor oil or power steering fluid .
A crossflow head gives better performance than a Reverse-flow cylinder head (though not as good as a uniflow), but the popular explanation put forward for this — that the gases do not have to change direction and hence are moved into and out of the cylinder more efficiently — is a simplification since there is no continuous flow because of valve opening and closing.
The Duramax V8 engine is a family of 6.6-liter diesel V8 engines produced by DMAX, a wholly owned subsidiary of General Motors in Moraine, Ohio.The Duramax block and heads are supplied from reliable vendors of General Motors.
The Vortec 5700 L31 (VIN code "R") is a 5.7L V8 truck engine. It is Chevrolet's last production first-generation small-block. The cylinder heads feature combustion chambers and intake ports very similar to those of the LT1 V8, but lacking the LT1's reverse-flow cooling and higher compression.