Search results
Results from the WOW.Com Content Network
For example, "five tenths," is typically a measurement or tolerance of five ten-thousandths of an inch, and written as 0.0005 inches. "Three tenths," as another example, is written as 0.0003 inches [9] Machining "to within a few tenths" is often considered very accurate, and at or near the extreme limit of tolerance capability in most contexts.
When using "hand in" to convert to hands and inches, the rounded hands and inches values are equivalent, and use the same fraction, if any. Special rounding of the inches value only occurs when "hand in" is the output.
The Metric Act of 1866, also known as the Kasson Act, is a piece of United States legislation that legally protected use of the metric system in commerce from lawsuit, and provided an official conversion table from U.S. customary units. [1]
By default, the output value is rounded to adjust its precision to match that of the input. An input such as 1234 is interpreted as 1234 ± 0.5, while 1200 is interpreted as 1200 ± 50, and the output value is displayed accordingly, taking into account the scale factor used in the conversion.
The United States adopted the conversion factor 1 metre = 39.37 inches by an act in 1866. [30] In 1893, Mendenhall ordered the physical realization of the inch to be based on the international prototype metres numbers 21 and 27, which had been received from the CGPM, together with the previously adopted conversion factor. [31]
Display sizes for screens on TVs and computer monitors are advertised and sold in inches (measured diagonally), although most boxes also state the size in centimeters. The original 1 ⁄ 4 inch (6.35 mm) phone connector jack dates back to 1878 [54] [55] [56] and still sees use in audio equipment and electric instruments. In many respects, it ...
The woman accused of stowing away on a Delta flight from New York to Paris was arrested again, this time while reportedly trying to get into Canada.
The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...