Search results
Results from the WOW.Com Content Network
Four-point measurement of resistance between voltage sense connections 2 and 3. Current is supplied via force connections 1 and 4. In electrical engineering, four-terminal sensing (4T sensing), 4-wire sensing, or 4-point probes method is an electrical impedance measuring technique that uses separate pairs of current-carrying and voltage-sensing electrodes to make more accurate measurements ...
Diagram of D'Arsonval/Weston type galvanometer. As the current flows from + terminal of the coil to − terminal, a magnetic field is generated in the coil.This field is counteracted by the permanent magnet and forces the coil to twist, moving the pointer, in relation to the field's strength caused by the flow of current.
Kelvin sensing is the standard term in the realm of [power] semiconductor testing. DFH 19:31, 7 December 2006 (UTC) [ reply ] OK, you seem to be more knowledgeable, so if you think its a good name change go ahead.
The operation of the Kelvin bridge is very similar to the Wheatstone bridge, but uses two additional resistors. Resistors R 1 and R 2 are connected to the outside potential terminals of the four terminal known or standard resistor R s and the unknown resistor R x (identified as P 1 and P′ 1 in the diagram).
Atomic Gravitational Wave Interferometric Sensor; Attitude control (spacecraft): Horizon sensor, Earth sensor, Moon sensor, Satellite Sensor, Sun sensor; Catadioptric sensor; Chemoreceptor; Compressive sensing; Cryogenic particle detectors; Dew warning; Diffusion tensor imaging; Digital holography; Electronic tongue; Fine Guidance Sensor; Flat ...
Atmospheric windows are useful for astronomy, remote sensing, telecommunications and other science and technology applications. In the study of the greenhouse effect, the term atmospheric window may be limited to mean the infrared window, which is the primary escape route for a fraction of the thermal radiation emitted near the surface.
Synchro systems were first used in the control system of the Panama Canal in the early 1900s to transmit lock gate and valve stem positions, and water levels, to the control desks. [ 1 ] View of the connection diagram of a synchro transmitter
A remote terminal unit (RTU) is a microprocessor-controlled electronic device that interfaces objects in the physical world to a distributed control system or SCADA (supervisory control and data acquisition) system by transmitting telemetry data to a master system, and by using messages from the master supervisory system to control connected objects. [1]