enow.com Web Search

  1. Ads

    related to: taco hot water recirculating pumps work diagram

Search results

  1. Results from the WOW.Com Content Network
  2. Circulator pump - Wikipedia

    en.wikipedia.org/wiki/Circulator_pump

    The traditional hot water recirculation system uses the existing cold water line as return line from the point of use located farthest from the hot water tank back to the hot water tank. The first of two system types has a pump mounted at the hot water heater while a "normally open" thermostatic control valve gets installed at the farthest ...

  3. Tankless water heating - Wikipedia

    en.wikipedia.org/wiki/Tankless_water_heating

    On-demand recirculating pumps are activated by push-button or other sensor. A water contacting temperature probe installed at the hot water usage point signals the pump to stop. Single-cycle pumping events only occur when hot water is needed, thereby preventing the energy waste associated with constantly heating water within piping.

  4. Centrifugal pump - Wikipedia

    en.wikipedia.org/wiki/Centrifugal_pump

    Warman centrifugal pump in a coal preparation plant application A pair of centrifugal pumps for circulating hot water within a hydronic heating system. Centrifugal pumps are used to transport fluids by the conversion of rotational kinetic energy to the hydrodynamic energy of the fluid flow. The rotational energy typically comes from an engine ...

  5. Forced circulation boiler - Wikipedia

    en.wikipedia.org/wiki/Forced_circulation_boiler

    The secondary pump takes the feed water going to the boiler and raises the pressure of the water going in. In a natural circulation boilers, the circulation of water is dependent on the differential pressures caused by the change of density in the water as it is heated. That is to say that as the water is heated and starts turning to steam, the ...

  6. Central heating - Wikipedia

    en.wikipedia.org/wiki/Central_heating

    Early hot water systems were used in Ancient Rome for heating the Thermæ. [13] Another early hot water system was developed in Russia for central heating of the Summer Palace (1710–1714) of Peter the Great in Saint Petersburg. Slightly later, in 1716, came the first use of water in Sweden to distribute heating in buildings.

  7. Heat trap - Wikipedia

    en.wikipedia.org/wiki/Heat_trap

    Microcirculation on the left: Heated water is rising into the pipe on top of the hot water tank, cooling off on the sides of the pipe and thence circulating back into the tank. Right: Circulation of hot water is inhibited by the loop in the pipe. Heat traps are valves or loops of pipe on the cold water inlet and hot water outlet of water heaters.

  8. Water heating - Wikipedia

    en.wikipedia.org/wiki/Water_heating

    They typically use low power heating elements, about 1 kW to 1.5 kW, and can provide hot water long enough for hand washing, or, if plumbed into an existing hot water line, until hot water arrives from a remote high capacity water heater. They may be used when retrofitting a building with hot water plumbing is too costly or impractical.

  9. Circulation evaporator - Wikipedia

    en.wikipedia.org/wiki/Circulation_evaporator

    Tubular forced circulation evaporators employs an axial circulation pump which navigates the flow of liquid in a circular motion through the system's heat exchanger in which it is superheated. Thereafter, when the liquid reaches the separator the liquid pressure decreases dramatically forcing a portion of the liquid to be rapidly boiled off.

  1. Ads

    related to: taco hot water recirculating pumps work diagram