Search results
Results from the WOW.Com Content Network
Most of the solids are removed by the septic tanks, so the treatment plant can be much smaller than a typical plant. In addition, because of the vast reduction in solid waste, a pumping system, rather than a gravity system, can be used to move the wastewater. The pipes have small diameters, typically 1.5 to 4 inches (4 to 10 cm).
The relatively grease-free water is then fed into the normal septic system.The food solids at the bottom and floating oil and grease must be periodically removed in a manner similar to septic tank pumping. [11] A traditional grease trap is not a food disposal unit. Unfinished food must be scraped into the garbage or food recycling bin.
Manhole covers may also be made from glass-reinforced plastic or other composite material (especially in Europe, or where cover theft is of concern). Because of law restricting acceptable manual handling weights, Europe has seen a move towards lighter weight composite manhole cover materials, which also have the benefits of greater slip ...
The cover section is the top most section of sanitary manholes. It consists of a frame and a manhole cover. [16] The covers are designed to withstand the loads of the traffic on top of the manholes. Some are suitable for vehicular traffic, and some are for foot traffic only. [7]
A septic drain field, a septic tank, and associated piping compose a septic system. The drain field typically consists of an arrangement of trenches containing perforated pipes and porous material (often gravel) covered by a layer of soil to prevent animals (and surface runoff) from reaching the wastewater distributed within those trenches. [1]
A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.
Since clean-out augers are limited in length, clean-outs should be placed in accessible locations at regular intervals throughout a drainage system (including outside the building). Minimum requirements are typically at the end of each branch in piping, just ahead of each water closet, at the base of each vertical stack and inside and outside ...
A septic tank is an underground chamber made of concrete, fiberglass, or plastic through which domestic wastewater flows for basic sewage treatment. [2] Settling and anaerobic digestion processes reduce solids and organics, but the treatment efficiency is only moderate (referred to as "primary treatment"). [2]