Search results
Results from the WOW.Com Content Network
In aqueous solution, ammonia deprotonates a small fraction of the water to give ammonium and hydroxide according to the following equilibrium: . NH 3 + H 2 O ⇌ NH + 4 + OH −.. In a 1 M ammonia solution, about 0.42% of the ammonia is converted to ammonium, equivalent to pH = 11.63 because [NH +
Pressure ρ of liquid ρ of vapor Δ vap H: The table above gives properties of the vapor–liquid equilibrium of anhydrous ammonia at various temperatures. The second column is vapor pressure in kPa. The third column is the density of the liquid phase. The fourth column is the density of the vapor.
Ammonia readily dissolves in water. In an aqueous solution, it can be expelled by boiling. The aqueous solution of ammonia is basic, and may be described as aqueous ammonia or ammonium hydroxide. [30] The maximum concentration of ammonia in water (a saturated solution) has a specific gravity of 0.880 and is often known as '.880 ammonia'. [31]
Life on Earth usually exists between the melting point and boiling point of water, at a pressure designated as normal pressure, between 0 and 100 °C (273 and 373 K). When also held to normal pressure, ammonia's melting and boiling points are −78 °C (195 K) and −33 °C (240 K) respectively.
Since 1982, STP has been defined as a temperature of 273.15 K (0 °C, 32 °F) and an absolute pressure of exactly 1 bar (100 kPa, 10 5 Pa). NIST uses a temperature of 20 °C (293.15 K, 68 °F) and an absolute pressure of 1 atm (14.696 psi, 101.325 kPa). [3] This standard is also called normal temperature and pressure (abbreviated as NTP).
A typical phase diagram.The solid green line applies to most substances; the dashed green line gives the anomalous behavior of water. In thermodynamics, the triple point of a substance is the temperature and pressure at which the three phases (gas, liquid, and solid) of that substance coexist in thermodynamic equilibrium. [1]
The gaseous state of water is lighter than air (density 0.804 g/L at STP, average molecular mass 18.015 g/mol) due to water's low molar mass when compared with typical atmospheric gases such as nitrogen gas (N 2). It is non-flammable and much cheaper than helium. The concept of using steam for lifting is therefore already 200 years old.
The pressure on a pressure-temperature diagram (such as the water phase diagram shown above) is the partial pressure of the substance in question. A phase diagram in physical chemistry , engineering , mineralogy , and materials science is a type of chart used to show conditions (pressure, temperature, etc.) at which thermodynamically distinct ...