Search results
Results from the WOW.Com Content Network
The specific weight, also known as the unit weight (symbol γ, the Greek letter gamma), is a volume-specific quantity defined as the weight W divided by the volume V of a material: = / Equivalently, it may also be formulated as the product of density, ρ, and gravity acceleration, g: = Its unit of measurement in the International System of Units (SI) is newton per cubic metre (N/m 3), with ...
The droplet concentration of a cloud is the number of water droplets in a volume of cloud, typically a cubic centimeter (Wallace, 2006). The formula for the droplet concentration is as follows. = / In this equation, N is the total number of water droplets in the volume, and V is the total volume of the cloud being measured.
The weight of the displaced fluid can be found mathematically. The mass of the displaced fluid can be expressed in terms of the density and its volume, m = ρV. The fluid displaced has a weight W = mg, where g is acceleration due to gravity. Therefore, the weight of the displaced fluid can be expressed as W = ρVg.
For example, in the brewing industry, the Plato table lists sucrose concentration by weight against true SG, and was originally (20 °C/4 °C) [7] i.e. based on measurements of the density of sucrose solutions made at laboratory temperature (20 °C) but referenced to the density of water at 4 °C which is very close to the temperature at which ...
[7] [8] A US liquid gallon can contain about 3.785 kilograms or 8.34 pounds of water at 3.98 °C (39.16 °F), and is about 16.7% less than the imperial gallon. There are four quarts in a gallon, two pints in a quart and 16 US fluid ounces in a US pint , which makes the US fluid ounce equal to 1 / 128 of a US gallon.
1 mL of water weighs 1 gram so a recipe calling for 300 mL (≈ 1 ⁄ 2 Imperial Pint) of water can simply be substituted with 300 g (≈ 10 oz.) of water. 1 fluid ounce of water weighs approximately 1 ounce so a recipe calling for a UK pint (20 fl oz) of water can be substituted with 20 oz of water.
In the oil industry, mud weight is the density of the drilling fluid and is normally measured in pounds per gallon (lb/gal) (ppg) or pound cubic feet (pcf) . [1] In the field it is measured using a mud scale or mud balance. Mud can weigh up to 22 or 23 ppg. A gallon of water typically weighs 8.33 pounds (or 7.48 ppg).
The gram per cubic centimetre is a unit of density in the CGS system, and is commonly used in chemistry. It is defined by dividing the CGS unit of mass, the gram, by the CGS unit of volume, the cubic centimetre. The official SI symbols are g/cm 3, g·cm −3, or g cm −3. It is equivalent to the units gram per millilitre (g/mL) and kilogram ...