Search results
Results from the WOW.Com Content Network
Pulsed DC (PDC) or pulsating direct current is a periodic current which changes in value but never changes direction. Some authors use the term pulsed DC to describe a signal consisting of one or more rectangular ("flat-topped"), rather than sinusoidal, pulses. [1] Pulsed DC is commonly produced from AC (alternating current) by a half-wave ...
Simple LED (Light Emitting Diode) circuit diagram. In electronics, an LED circuit or LED driver is an electrical circuit used to power a light-emitting diode (LED). The circuit must provide sufficient current to light the LED at the required brightness, but must limit the current to prevent damaging the LED.
In the non-tripped state, the outputs periodically pulse low. The protective device checks the output, to make sure it does indeed go low when commanded. If not, the output may have failed or has shorted to 24V somewhere else. Between OSSD1 and OSSD2 the pulse intervals are staggered to check for crisscrossed wiring between the two. [1]
Schematic diagram of an opto-isolator showing source of light (LED) on the left, dielectric barrier in the center, and sensor (phototransistor) on the right [note 1]. An opto-isolator (also called an optocoupler, photocoupler, or optical isolator) is an electronic component that transfers electrical signals between two isolated circuits by using light. [1]
In some designs (as shown in the diagrams) the secondary voltage V s adds to the source voltage V b; in this case because the voltage across the primary (during the time the switch is closed) is approximately V b, V s = (N+1)×V b. Alternately the switch may get some of its control voltage or current directly from V b and the rest from the ...
Examples of pulse shapes: (a) rectangular pulse, (b) cosine squared (raised cosine) pulse, (c) Dirac pulse, (d) sinc pulse, (e) Gaussian pulse A pulse in signal processing is a rapid, transient change in the amplitude of a signal from a baseline value to a higher or lower value, followed by a rapid return to the baseline value.
Its output approximates a voltage-shifted version of the input's upper envelope. Between the circuit's input and output is a diode that performs half-wave rectification , allowing substantial current flow only when the input voltage is around a diode drop higher than the output terminal.
A class of laboratory power meters has an extended sensitivity, of the order of -110 dBm. This is achieved by using a very small detector and lens combination, and also a mechanical light chopper at typically 270 Hz, so the meter actually measures AC light. This eliminates unavoidable dc electrical drift effects.