Search results
Results from the WOW.Com Content Network
The vertical exaggeration is given by: = where VS is the vertical scale and HS is the horizontal scale, both given as representative fractions.. For example, if 1 centimetre (0.39 in) vertically represents 200 metres (660 ft) and 1 centimetre (0.39 in) horizontally represents 4,000 metres (13,000 ft), the vertical exaggeration, 20×, is given by:
In synoptic scale we can expect horizontal velocities about U = 10 1 m.s −1 and vertical about W = 10 −2 m.s −1. Horizontal scale is L = 10 6 m and vertical scale is H = 10 4 m. Typical time scale is T = L/U = 10 5 s. Pressure differences in troposphere are ΔP = 10 4 Pa and density of air ρ = 10 0 kg⋅m −3. Other physical properties ...
In atmospheric, earth, and planetary sciences, a scale height, usually denoted by the capital letter H, is a distance (vertical or radial) over which a physical quantity decreases by a factor of e (the base of natural logarithms, approximately 2.718).
Examples include a 3-dimensional scale model of a building or the scale drawings of the elevations or plans of a building. [1] In such cases the scale is dimensionless and exact throughout the model or drawing. The scale can be expressed in four ways: in words (a lexical scale), as a ratio, as a fraction and as a graphical (bar) scale.
A base-10 log scale is used for the Y-axis of the bottom left graph, and the Y-axis ranges from 0.1 to 1000. The top right graph uses a log-10 scale for just the X-axis, and the bottom right graph uses a log-10 scale for both the X axis and the Y-axis. Presentation of data on a logarithmic scale can be helpful when the data:
Each iteration of the Sierpinski triangle contains triangles related to the next iteration by a scale factor of 1/2. In affine geometry, uniform scaling (or isotropic scaling [1]) is a linear transformation that enlarges (increases) or shrinks (diminishes) objects by a scale factor that is the same in all directions (isotropically).
Even more ridiculous: Pendrith said that was his eighth career albatross, compared with three holes-in-one. Folks, that’s just silly. Also, you definitely want Pendrith on your alternate-shot ...
The datum may be permanently fixed or the height gauge may have provision to adjust the scale, this is done by sliding the scale vertically along the body of the height gauge by turning a fine feed screw at the top of the gauge; then with the scriber set to the same level as the base, the scale can be matched to it.