Search results
Results from the WOW.Com Content Network
A scale ruler is a tool for measuring lengths and transferring measurements at a fixed ratio of length; two common examples are an architect's scale and engineer's scale.In scientific and engineering terminology, a device to measure linear distance and create proportional linear measurements is called a scale.
An order from the engineering department (to be followed by the production department or vendor) overriding/superseding a detail on the drawing, which gets superseded with revised information. Also called by various other names, such as engineering change order (ECO), engineering change notice (ECN), drawing change notice (DCN), and so on.
An engineering drawing is a type of technical drawing that is used to convey information about an object. A common use is to specify the geometry necessary for the construction of a component and is called a detail drawing.
Engineering notation or engineering form (also technical notation) is a version of scientific notation in which the exponent of ten is always selected to be divisible by three to match the common metric prefixes, i.e. scientific notation that aligns with powers of a thousand, for example, 531×10 3 instead of 5.31×10 5 (but on calculator displays written without the ×10 to save space).
In certain NMRA scales an alternative designation is sometimes used corresponding the length of one prototype foot in scale either in millimetres or in inches. For instance, 3.5 mm scale is the same as HO. For HO and O-scales, NMRA uses the letter "O" whereas NEM uses the number zero (H0 instead of HO).
The length of the line on the linear scale is equal to the distance represented on the earth multiplied by the map or chart's scale. In most projections, scale varies with latitude, so on small scale maps, covering large areas and a wide range of latitudes, the linear scale must show the scale for the range of latitudes covered by the map. One ...
An architect's scale. A scale ruler is a scaled, three-edged ruler which has six different scales marked to its sides. A typical combination for building details is 1:20, 1:50, 1:100, 1:25, 1:75 and 1:125. There are separate rulers for zoning work as well as for inch units. Today scale rulers are made of plastic, formerly they were made of ...
Engineering is the discipline and profession that applies scientific theories, mathematical methods, and empirical evidence to design, create, and analyze technological solutions, balancing technical requirements with concerns or constraints on safety, human factors, physical limits, regulations, practicality, and cost, and often at an industrial scale.