Search results
Results from the WOW.Com Content Network
For example, such a regulation might limit the concentration of NOx to 55 ppmv in a dry combustion exhaust gas corrected to 3 volume percent O 2. As another example, a regulation might limit the concentration of particulate matter to 0.1 grain per standard cubic foot (i.e., scf) of dry exhaust gas corrected to 12 volume percent CO 2.
Selective catalytic reduction (SCR) means converting nitrogen oxides, also referred to as NO x with the aid of a catalyst into diatomic nitrogen (N 2), and water (H 2 O). A reductant, typically anhydrous ammonia (NH 3), aqueous ammonia (NH 4 OH), or a urea (CO(NH 2) 2) solution, is added to a stream of flue or exhaust gas and is reacted onto a ...
Selective non-catalytic reduction (SNCR) is a method to lessen nitrogen oxide emissions in conventional power plants that burn biomass, waste and coal.The process involves injecting either ammonia or urea into the firebox of the boiler at a location where the flue gas is between 1,400 and 2,000 °F (760 and 1,090 °C) to react with the nitrogen oxides formed in the combustion process.
For example, 2010 EPA emissions requirements require full DEF coolant flow within 70 minutes. [ 18 ] [ 19 ] In Europe, Regulation (EC) No 692/2008 [ 20 ] specified in Annex XVI point 10 that DEF from a frozen tank at a core temperature of −15 °C (5 °F) must become available within 20 minutes when starting the engine at −15 °C (5 °F).
As an example, a measured NO x concentration of 45 ppmv in a dry gas having 5 volume % O 2 is: 45 × ( 20.9 - 3 ) ÷ ( 20.9 - 5 ) = 50.7 ppmv of NO x. when corrected to a dry gas having a specified reference O 2 content of 3 volume %. Note: The measured gas concentration C m must first be corrected to a dry basis before using the above equation.
A NO x adsorber is designed to reduce oxides of nitrogen emitted in the exhaust gas of a lean burn internal combustion engine.Lean burn engines, particularly diesels, present a special challenge to emission control system designers because of the relatively high levels of O 2 (atmospheric oxygen) in the exhaust gas.
NO x emissions may be reduced by up to 30% using this technology. This technique is used in 13 pulverized coal-fired units on a total capacity of 2.7 GW e. [5] Via fuel staged supply, a NO x reduction rate from 50-75% is also possible, though minor temperature instabilities at the reduction zone can occur and a lower temperature is necessary ...
The end result of this recirculation of both exhaust gas and crankcase oil vapour is again an increase in soot production, which however is effectively countered by the DPF, which collects these and in the end will burn those unburnt particles during regeneration, converting them into CO2 and water vapour emissions, that - unlike NOx gases ...