Search results
Results from the WOW.Com Content Network
Reducing energy loads of main systems equipment providing heating, cooling and water heating can be achieved by upgrading physical equipment including replacing older equipment with newer, more energy-efficient units, upgrading the building envelope with insulation and higher-grade windows, creating more efficient zoning within heating/cooling air distribution ducts, and deployment of advanced ...
An electrical load is an electrical component or portion of a circuit that consumes (active) electric power, [1] [2] such as electrical appliances and lights inside the home. The term may also refer to the power consumed by a circuit. This is opposed to a power supply source, such as a battery or generator, which provides power. [2]
In 1999, the US Department of Energy projected that office equipment would be the fastest-growing commercial end use between 1998 and 2020. [5] The Commercial Buildings Energy Consumption Survey (CBECS), a national sample survey project of the US Energy Information Administration, reported that based on 2003 data, 19% of the total energy of US office buildings is attributed to plug load energy ...
Aluminum building wiring is a type of electrical wiring for residential construction or houses that uses aluminum electrical conductors. Aluminum provides a better conductivity-to-weight ratio than copper, and therefore is also used for wiring power grids , including overhead power transmission lines and local power distribution lines , as well ...
In electrical engineering the load factor is defined as the average load divided by the peak load in a specified time period. [1] It is a measure of the utilization rate, or efficiency of electrical energy usage; a high load factor indicates that load is using the electric system more efficiently, whereas consumers or generators that underutilize the electric distribution will have a low load ...
IEC 60364 Electrical Installations for Buildings is the International Electrotechnical Commission (IEC)'s international standard on electrical installations of buildings.This standard is an attempt to harmonize national wiring standards in an IEC standard and is published in the European Union by CENELEC as "HD 60364".
Control of D.C. electromagnetic loads having economy resistors in the circuit: 60947-5-1 DC-20: Connecting and disconnecting under no-load conditions: 60947-5-1 DC-21: Switching of resistive loads, including moderate overloads: 60947-5-1 DC-22: Switching of mixed resistive and inductive loads, including moderate overloads (i.e. shunt motors ...
Since electrical energy is a form of energy that cannot be effectively stored in bulk, it must be generated, distributed, and consumed immediately. When the load on a system approaches the maximum generating capacity, network operators must either find additional supplies of energy or find ways to curtail the load, hence load management.