Search results
Results from the WOW.Com Content Network
Flat 5-pin connector (Towing vehicle side) This contact is not as common, but is compatible with the 4-pin connector in the way that a towing vehicle with this connector can be connected to a trailer with the 4-pin flat plug. The extra connection is often used to block the surge brakes when reversing with the trailer. #
12 Volt 7-pin trailer connector ISO 7638-2 for ABS and EBS (Towing vehicle side) Physical design according to standard ISO 7638-2. [4] [6] [7] This connector is intended to be used for 12V ABS and EBS on heavy duty trailers. Identified by key tab on outer ring between pin 3 and 4. #
A trailer connector is a multi-pole electrical connector between a towing vehicle (car, truck) and a trailer. It is intended primarily to supply automotive lighting on the trailer, but also provide management and supply to other loads. It is also referred to as "trailer wire," "trailer cable," or "trailer connecting cable."
Agricultural implement ISOBUS plug. ISO 11783, known as Tractors and machinery for agriculture and forestry—Serial control and communications data network (commonly referred to as "ISOBUS") is a communication protocol for the agriculture industry based on, and harmonized with, the SAE J1939 protocol (which is based on the CAN bus).
The other main mechanism for attaching a load is through a drawbar, a single point, pivoting attachment where the implement or trailer is not in a fixed position with respect to the tractor. The primary benefit of the three-point hitch system is to transfer the weight and resistance of an implement to the drive wheels of the tractor .
The trailer needed to be raised so that the trailer's pin would be able to drop into the central hole of the fifth wheel. Fifth wheels were originally not a complete circle and were hand forged. When mass production of buggy parts began in the early 19th century, fifth wheels were among the first products to be made.
Ground for pin 9 [a] ISO 11446:2004 specifies a 13-pole electrical connector between towing and towed vehicles with 12 volt electrical system . It was developed in 1987 by Erich Jaeger [ 1 ] to replace older 7-pin plugs.
Trailer connector according to NATO STANAG 4007 NATO uses a 12-pin connector [ NATO 1 ] [ NATO 2 ] according to STANAG 4007. [ 1 ] However, note that there are often deviations from the standard depending on which country it is applied, which means that the table below may not be accurate.