Ads
related to: evap pressure sensor nissan p0450 valve module 4 7 sam capstone project 1awalmart.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
The purge valve controls the purge vapor purge line, through which the manifold vacuum pulls air through the vapor storage device and purges it of fuel vapors. The electronic control unit (ECU) controls the opening and closing of this valve. [8] [dead link ]
The 4N71 was a 4-speed automatic transmission from Nissan Motors. It was available as either a light-duty ("L4N71B") or medium-duty ("E4N71B") unit for rear wheel drive vehicles with longitudinal engines. The latter used an electronically controlled lock up torque converter. Applications:
1986–2007 Nissan TD engine – 2.3/2.5/2.7/4.2 L; ... Many standard DOHC Nissan engines featured Variable Valve Timing, such as the VG30DETT, and as such do not use ...
The way they do this is during a deceleration of the vehicle when there is low absolute pressure in the intake manifold (i.e., a high vacuum present in the intake manifold relative to the outside air) the powertrain control module (PCM) will open the EGR valve and then monitor the MAP sensor's values. If the EGR is functioning properly, the ...
A second function of the PCV valve is to act as a flame arrester and to prevent positive pressure from the intake system from entering the crankcase. This can happen on turbocharged engines or when a backfire takes place, and the positive pressure could damage the crankcase seals and gaskets, or even cause a crankcase explosion. The PCV valve ...
A power-train control module, abbreviated PCM, is an automotive component, a control unit, used on motor vehicles. It is generally a combined controller consisting of the engine control unit (ECU) and the transmission control unit (TCU). On some cars, such as many Chryslers, there are multiple computers: the PCM, the TCU, and the Body Control ...
The TPS sensor along with the vehicle speed sensor are the two main inputs for most TCUs. Older transmissions use this to determine engine load, with the introduction of drive-by-wire technology, this is often a shared input between the ECU and TCU. The input is used to determine the optimum time and characteristics for a gear change according ...
Ads
related to: evap pressure sensor nissan p0450 valve module 4 7 sam capstone project 1awalmart.com has been visited by 1M+ users in the past month