Search results
Results from the WOW.Com Content Network
Combinational logic is used in computer circuits to perform Boolean algebra on input signals and on stored data. Practical computer circuits normally contain a mixture of combinational and sequential logic. For example, the part of an arithmetic logic unit, or ALU, that does mathematical calculations is constructed using combinational logic.
Circuit simulators such as SPICE may be used. This is usually the most accurate, but slowest, method. DCL, as defined above, can be used for interconnecting as well as gate delay. Often, it makes sense to combine the calculation of a gate and all the wires connected to its output. This combination is often called the stage delay.
Figure 1: Schematic of an electrical circuit illustrating current division. Notation R T refers to the total resistance of the circuit to the right of resistor R X.. In electronics, a current divider is a simple linear circuit that produces an output current (I X) that is a fraction of its input current (I T).
Many circuits can be analyzed as a combination of series and parallel circuits, along with other configurations. In a series circuit, the current that flows through each of the components is the same, and the voltage across the circuit is the sum of the individual voltage drops across each component. [1]
Circuit minimization may be one form of logic optimization used to reduce the area of complex logic in integrated circuits. With the advent of logic synthesis , one of the biggest challenges faced by the electronic design automation (EDA) industry was to find the most simple circuit representation of the given design description.
Any combination of Hookean (linear-response) springs in series or parallel behaves like a single Hookean spring. The formulas for combining their physical attributes are analogous to those that apply to capacitors connected in series or parallel in an electrical circuit .
Randles circuit schematic. In electrochemistry, a Randles circuit is an equivalent electrical circuit that consists of an active electrolyte resistance R S in series with the parallel combination of the double-layer capacitance C dl and an impedance (Z w) of a faradaic reaction.
In digital circuits, an adder–subtractor is a circuit that is capable of adding or subtracting numbers (in particular, binary). Below is a circuit that adds or subtracts depending on a control signal. It is also possible to construct a circuit that performs both addition and subtraction at the same time. [1]