Search results
Results from the WOW.Com Content Network
Inclusions are present in any steel to a greater or lesser extent according to the mixture and conditions of production. Usually the amount of non-metallic inclusions in steel is not higher than 0.1%. However, the number of inclusions in metal is very high because of their extremely small size. Non-metallic inclusions in steel are foreign ...
This microstructure is advantageous over other microstructures for steel because of its chaotic ordering, which increases toughness. [ 1 ] Acicular ferrite is formed in the interior of the original austenitic grains by direct nucleation on the inclusions, resulting in randomly oriented short ferrite needles with a 'basket weave' appearance.
Mie scattering (sometimes referred to as a non-molecular scattering or aerosol particle scattering) takes place in the lower 4,500 m (15,000 ft) of the atmosphere, where many essentially spherical particles with diameters approximately equal to the wavelength of the incident ray may be present. Mie scattering theory has no upper size limitation ...
In practice, however, material inconsistencies such as internal cracks, blowholes, cavities in welds, air holes in metal parts, and non-metallic or foreign inclusions can occur. These defects act as discontinuities within the component, disrupting the uniform distribution of stress and thereby leading to stress concentration.
It is also a significant cause of failure in components subjected to rolling or rolling/sliding contacts, such as rolling-contact bearings, gears, and cam/tappet arrangements. [5] The alternating stress field in RCF can lead to material removal, varying from micro- and macro- pitting in conventional bearing steels to delamination in hybrid ...
A turret lathe operator machining metallic parts for transport planes in the 1940s. An alternative in metallurgy is to consider various malleable alloys such as steel, aluminium alloys and similar as metals, and other materials as nonmetals; [20] fabricating metals is termed metalworking, [21] but there is no corresponding term for nonmetals. A ...
A casting defect is an undesired irregularity in a metal casting process. Some defects can be tolerated while others can be repaired, otherwise they must be eliminated. They are broken down into five main categories: gas porosity, shrinkage defects, mould material defects, pouring metal defects, and metallurgical defects.
PSB structure (adopted from [7]). Persistent slip-bands (PSBs) are associated with strain localisation due to fatigue in metals and cracking on the same plane. Transmission electron microscopy (TEM) and three-dimensional discrete dislocation dynamics (DDD [8]) simulation were used to reveal and understand dislocations type and arrangement/patterns to relate it to the sub-surface structure.