Search results
Results from the WOW.Com Content Network
The NIST document gives conversion factors correct to 7 places. Factors in bold are exact. If exact factors have more than 7 places, they are rounded and no longer exact. This convert module replaces these rounded figures with the exact figures. For example, the NIST document has 1 square mile = 2.589 988 E+06 square meters.
Factors in bold are exact. If exact factors have more than 7 places, they are rounded and no longer exact. This convert module replaces these rounded figures with the exact figures. For example, the NIST document has 1 square mile = 2.589 988 E+06 square meters. The convert template has 1 square mile = 2,589,988.110336 square meters.
The quantity "1 ppm" can be used for a mass fraction if a water-borne pollutant is present at one-millionth of a gram per gram of sample solution. When working with aqueous solutions, it is common to assume that the density of water is 1.00 g/mL. Therefore, it is common to equate 1 kilogram of water with 1 L of water.
Molar concentration or molarity is most commonly expressed in units of moles of solute per litre of solution. [1] For use in broader applications, it is defined as amount of substance of solute per unit volume of solution, or per unit volume available to the species, represented by lowercase : [2]
1 Nm 3 of any gas (measured at 0 °C and 1 atmosphere of absolute pressure) equals 37.326 scf of that gas (measured at 60 °F and 1 atmosphere of absolute pressure). 1 kmol of any ideal gas equals 22.414 Nm 3 of that gas at 0 °C and 1 atmosphere of absolute pressure ... and 1 lbmol of any ideal gas equals 379.482 scf of that gas at 60 °F and ...
where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. [6]
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.
An entry defining a unit for Val is a single line under a section heading. [1] It starts with the unit code, followed by at least two spaces and a link.If you are adding a group of related units, you can enter a blank line around them to group them in the report at Val/list.