Search results
Results from the WOW.Com Content Network
A related but separate gauge is the loading gauge: a diagram or physical structure that defines the maximum height and width dimensions in railway vehicles and their loads. The difference between these two gauges is called the clearance .
An architectural drawing or architect's drawing is a technical drawing of a building (or building project) that falls within the definition of architecture.Architectural drawings are used by architects and others for a number of purposes: to develop a design idea into a coherent proposal, to communicate ideas and concepts, to convince clients of the merits of a design, to assist a building ...
Engineering drawings could be readily doubled (or halved) in size and put on the next larger (or, respectively, smaller) size of paper with no waste of space. And the metric technical pens were chosen in sizes so that one could add detail or drafting changes with a pen width changing by approximately a factor of the square root of 2. A full set ...
A door frame, window frame, door surround, window surround, or niche surround is the architectural frame around an aperture such as a door or window.. Entrance door and surround of a house in Charleston, South Carolina A interior doorway consisting of door, transom, and door surround in a historic house in Kentucky, United States
Hydrolevelling is an alternative to measuring depth with clinometer and tape that has a long history of use in Russia. [4] The technique is regularly used in building construction for finding two points with the same height, as in levelling a floor.
The assessment length or evaluation length is the length of data that will be used for analysis. Commonly one sampling length is discarded from each end of the measurement length. 3D measurements can be made with a profilometer by scanning over a 2D area on the surface.
Modern micrometer with a reading of 1.639 ± 0.005 mm. Assuming no zero error, this is also the measurement. (One may need to enlarge the image to read it.) Outside, inside, and depth micrometers. The outside micrometer has a unit conversion chart between fractional and decimal inch measurements etched onto the frame
Width and breadth usually refer to a shorter dimension than length. Depth is used for the measure of a third dimension. [2] Length is the measure of one spatial dimension, whereas area is a measure of two dimensions (length squared) and volume is a measure of three dimensions (length cubed).