Search results
Results from the WOW.Com Content Network
Wireless Engineering Research and Education Center is one of three research centers. The university also offers a Bachelor of Wireless Engineering degree with a Wireless Electrical Engineering major. [7] [8] [9] Bradley University offers an undergraduate and a graduate degree in its Microwave and Wireless Engineering Program. It has an Advanced ...
Radio-frequency (RF) engineering is a subset of electrical engineering involving the application of transmission line, waveguide, antenna, radar, and electromagnetic field principles to the design and application of devices that produce or use signals within the radio band, the frequency range of about 20 kHz up to 300 GHz.
ANSI and IEC standard schematic symbol for a circulator (with each waveguide or transmission line port drawn as a single line, rather than as a pair of conductors). In electrical engineering, a circulator is a passive, non-reciprocal three- or four-port device that only allows a microwave or radio-frequency (RF) signal to exit through the port directly after the one it entered.
In radio-frequency engineering and communications engineering, a waveguide is a hollow metal pipe used to carry radio waves. [1] This type of waveguide is used as a transmission line mostly at microwave frequencies, for such purposes as connecting microwave transmitters and receivers to their antennas, in equipment such as microwave ovens, radar sets, satellite communications, and microwave ...
Microwave signals are normally limited to the line of sight, so long-distance transmission using these signals requires a series of repeaters forming a microwave relay network. It is possible to use microwave signals in over-the-horizon communications using tropospheric scatter , but such systems are expensive and generally used only in ...
Under experimental conditions, microwave conversion efficiency was measured to be around 54% across one meter. [121] A change to 24 GHz has been suggested as microwave emitters similar to LEDs have been made with very high quantum efficiencies using negative resistance, i.e., Gunn or IMPATT diodes, and this would be viable for short range links.
In this military radar, microwave radiation is transmitted between the source and the reflector by a waveguide. The figure suggests that microwaves leave the box in a circularly symmetric mode (allowing the antenna to rotate), then they are converted to a linear mode, and pass through a flexible stage.
In microwave and radio-frequency engineering, a stub or resonant stub is a length of transmission line or waveguide that is connected at one end only. The free end of the stub is either left open-circuit, or short-circuited (as is always the case for waveguides).