enow.com Web Search

  1. Ads

    related to: sealant coverage per tube of glass roof coating and insulation

Search results

  1. Results from the WOW.Com Content Network
  2. Insulated glazing - Wikipedia

    en.wikipedia.org/wiki/Insulated_glazing

    Fitting a second pane of glass to improve insulation began in Scotland, Germany, and Switzerland in the 1870s. [3] Insulating glass is an evolution from older technologies known as double-hung windows and storm windows. Traditional double-hung windows used a single pane of glass to separate the interior and exterior spaces.

  3. Building insulation material - Wikipedia

    en.wikipedia.org/wiki/Building_insulation_material

    While open-cell foams typically have R-values of 3 to 4 per inch (RSI-0.53 to RSI-0.70 per inch), closed-cell foams can attain R-values of 5 to 8 per inch (RSI-0.88 to RSI-1.41 per inch). This is important if space is limited, because it allows a thinner layer of insulation to be used.

  4. Butyl rubber - Wikipedia

    en.wikipedia.org/wiki/Butyl_rubber

    Butyl rubber sealant is used for damp proofing, rubber roof repair and for maintenance of roof membranes (especially around the edges). It is important [citation needed] to have the roof membrane fixed, as a lot of fixtures (e.g., air conditioner vents, plumbing, and other pipes) can considerably loosen it.

  5. Vapor barrier - Wikipedia

    en.wikipedia.org/wiki/Vapor_barrier

    Elastomeric coatings can provide a vapor barrier and water proofing with permeability ratings of .016 perm rating with 10 mils/min. of coating and can be applied on interior or exterior surfaces. Aluminum foil, 0.05 US perm (2.9 SI perm). Paper-backed aluminum.

  6. Spray foam - Wikipedia

    en.wikipedia.org/wiki/Spray_foam

    Polyurethane is a closed-cell foam insulation material that initially contains a low-conductivity gas in its cells. [6] As a result of the high thermal resistance of the gas, spray polyurethane insulation typically has an initial R-value around R-3.4 to R-6.7 per inch. [6] In comparison, glass wool typically has an R-Value of only R-3 to R-4 ...

  7. Solar thermal collector - Wikipedia

    en.wikipedia.org/wiki/Solar_thermal_collector

    Glass-glass tubes have a very reliable seal, but the two layers of glass reduce the amount of sunlight that reaches the absorber. The selective coating can be deposited on the inner borosilicate tube (high vacuum side) to avoid this, but heat has then to flow through the poorly conducting glass thickness of the inner tube in this case.

  8. Roof insurance: ACV vs. replacement cost - AOL

    www.aol.com/finance/roof-insurance-acv-vs...

    If your home is insured for $100,000, which includes your roof, and you have 125 percent extended replacement cost coverage, you actually have $125,000 in coverage, should the $100,000 not be ...

  9. Roof coating - Wikipedia

    en.wikipedia.org/wiki/Roof_coating

    This means a roof coating actually becomes the top layer of a composite roof membrane and underlying system. As such, the roof coating is the topmost layer of protection for the membrane, receiving the impact of sunlight (both infrared and ultraviolet (UV)), rain, hail and physical damage. Roof Coatings should not be confused with deck coatings.

  1. Ads

    related to: sealant coverage per tube of glass roof coating and insulation